Leveling The Dryer; Installation On An Elevated Base; Coin Mechanism; Communication Module Xkm Rs232 - Miele PT 8257 WP Operating And Installation Instructions

Leveling the dryer

The dryer and the heat pump do not need to be
installed on a base. However, adjustments must be
made to compensate for any unevenness in the floor.
The dryer and the heat pump must be level for proper
operation.
Level the dryer and the heat pump by adjusting the
dryer's four adjustable feet (A).
Once leveled, the discs (B) must be screwed tight to
the dryer's base plate.
Prior to initial startup, the system must be adapted
to ambient temperature and remain still for at least
one hour.

Installation on an elevated base

The dryer can be installed on an elevated concrete
base.
,
If installing the heat pump dryer on an existing
concrete base, it must be secured with retaining
clips. Otherwise, the heat pump dryer may fall off
the base.
^ Secure the front feet of the dryer with the retaining
clips provided.
b Drill holes for retaining clips

Coin mechanism

The dryer can be equipped with a coin mechanism*.
This requires an adapter*. The necessary
reprogramming of the dryer must be performed by a
Miele Service Technician.
Empty the coin box on a daily basis. This prevents
the coins and tokens from accumulating and causing
a malfunction.
* can be ordered from Miele.

Communication module XKM RS232

(where available)
The communication module makes it possible to
connect the dryer to a PC (personal computer) via a
serial interface.
The outlet for the module is located on the back of the
dryer.
This requires a special Editor Program which is
available from the Miele Professional Department.
Installation
31