Installation - Miele PT 8257 WP Operating And Installation Instructions

The dryer must be installed and tested by Miele's
Technical Service Department or an authorized
dealer.
This appliance must be installed in accordance with
the applicable regulations and may be used only in
rooms with adequate ventilation.
Read the instructions prior to installation and use of
this appliance.
Do not put the dryer in rooms where the temperature
may drop below freezing.
,
The dryer and the heat pump must not be
transported without a shipping pallet.
The dryer and heat pump modules must be
separated when being transported even over short
distances. Transporting these modules as a single
unit is not permitted and may result in damage.
The system may be transported only using suitable
transport aids.
Avoid tilting the heat exchanger more than 30°.
Following transport, the heat pump should rest for
one hour before being activated. The resting phase
should be extended up to 24 hours following any
heavy shaking or tilting beyond 30°.
At the installation location, lift the dryer and the heat
pump from the shipping pallet using appropriate
lifting equipment.
For ease of maintenance and servicing, the minimum
dimensions and distance to the wall with passage
must be observed.
Minimum distance to the wall and accessibility of the
maintenance passage 19 11/16" (500 mm).
PT 8257 / 8337
x 55 1/8" (1400 mm)
y 35 11/16" (906 mm)
7
z 47 /
16
13
54

Installation

" (1205 mm) /
/ " (1393 mm)
16
29