Related Manuals for IDEAL Classic Combi NF 280
Summary of Contents for IDEAL Classic Combi NF 280
- Page 1 Classic Combi NF 280 User's Instructions Wall Mounted, Fanned, Balanced Flue Gas Boiler Natural Gas Model Classic G.C. Appliance No. NF 280 47 415 08 NOTE TO THE INSTALLER: LEAVE THESE INSTRUCTIONS ADJACENT TO THE GAS METER...
-
Page 2: To Light The Boiler
At higher domestic hot water draw-off rates (greater than 6.0 litre/min. - 1.3 gpm) the boiler will fire at full gas rate. CENTRAL HEATING The Classic Combi NF 280 is a combination boiler providing both central heating and instantaneous The boiler control, firing at full gas rate, automatically maintains the central heating radiator temperature at approximately 80 domestic hot water. -
Page 3: Boiler Controls
1-5 in 'To light the boiler'. MAINTENANCE If the cutout condition still persists turn off the boiler and consult The appliance should be serviced at least once a year by a your local Corgi resgistered installer. Corgi registered installer. Ideal Classic Combi NF... - Page 4 CARADON IDEAL Ltd. pursues a policy of continuing improvement in the design and performance of its products. The THIS SYMBOL IS YOUR right is therefore reserved to vary specification without notice. ASSURANCE OF QUALITY These appliances are designed for use with Natural CARADON IDEAL Ltd.,...
Need help?
Do you have a question about the Classic Combi NF 280 and is the answer not in the manual?
Questions and answers
Pilot light will not light
The pilot light on the IDEAL Classic Combi NF 280 may not ignite due to several possible reasons:
1. Electricity Supply Off – Ensure the boiler’s electricity supply is switched on.
2. Burner On/Off Switch Off – Check that the burner on/off switch (C) is set to ON.
3. CH/HW Switch Setting – Verify that the CH/HW switch (B) is set correctly for hot water or heating.
4. Hot Water Taps Open – Ensure all hot water taps are turned off before attempting to ignite the boiler.
5. External Controls Off – Check that external controls like the programmer and room thermostat are switched on.
6. Casing Not Properly Fitted – The boiler will not operate if the casing is not correctly fitted and forming a proper seal.
If the issue persists, professional servicing may be required.
This answer is automatically generated