Table of Contents
Advertisement
Quick Links
D
S
ean
toves
Dean Forge Fabrication Ltd. Dean Prior, Buckfastleigh, Devon TQ11 0LS
T e l: 0 1 3 6 4 6 4 3 5 7 4
w w w.d e a n–f o r g e.c o.u k
e m a i l: s t o v e s @ d e a n-f o r g e.c o.u k
Operating Instructions For The Dean Forge Dartmoor Inset Stove
All stoves meet the essential type test requirement BS EN13229:2001 +
A1:2003 +A 2:2004
Safety Note
Warning- The external parts of the appliance will get very hot to the touch and due care will be
needed when operating.
All stoves before being operated must be checked that the installation complies to all local, national
and European standards.
Before the stove is first used or when fitting other appliances into the room, please check that adequate
air vents are in place to cover the requirements of such appliances.
Extractor fans when operating in the same room or space as the appliance may cause problems.
Wood & Suitable fuels
Dry wood, 18% moisture content or below must be used or the stove and flue will tar up and the
door won't stay clean.
Wood is best seasoned by splitting it into a log and drying it out for 2 years in a covered area so the air
can pass. Peat can also be used but must be dry.
When used as a Multi Fuel use only fuels recommended for enclosed appliances.
Please Note: Appliances should not be used as general incinerators or with non-recommended fuels.
At no time should liquid accelerants I.e: Paraffin, Petrol, BBQ lighting liquid Etc be used.
The chimney needs to be swept at least once a year.
1
Advertisement
Table of Contents
Related Manuals for Dean Dartmoor 5
Summary of Contents for Dean Dartmoor 5
- Page 1 Dean Forge Fabrication Ltd. Dean Prior, Buckfastleigh, Devon TQ11 0LS T e l: 0 1 3 6 4 6 4 3 5 7 4 w w w.d e a n–f o r g e.c o.u k e m a i l: s t o v e s @ d e a n-f o r g e.c o.u k...
-
Page 2: Controlling The Stove
Door Operation & controls The door handle can become very hot so use the glove provided. A tool is provided to control the spin wheel and air wash lever. Controlling the stove Diagram A: Primary air control (A) on front of door. Secondary air control (B) below the ash shelf The primary air control (A) is a spin wheel on the door. - Page 3 Please Note: For long periods of burning you will need to use seasoned hard wood. Longer periods of burning may cause the door glass to blacken, but this can be cleared when you get the fire back up to temperature and providing the secondary air control is slightly open this will then stay clear. When loading the fire be careful not to leave logs projecting over the log retainer as you may crack the glass when closing the door.
-
Page 4: Pre-Season Check
Pre-Season Check: The chimney needs to be swept at least once a year. The chimney must be checked for blockages before lighting i.e.: bird’s nests This is probably the time to have the chimney swept before the beginning of the seasons. Before lighting at the beginning of the season or after prolonged shutdown periods, check the door seals are in good condition;... -
Page 5: Health And Safety Precautions
All stoves are tested to nominal outputs and will well exceed these kilowatt ratings. Chimney All Dean Stoves must have a chimney at least 4m high measuring from the stove outlet, the chimney outlet must not be less than 150mm (6”). The installation of a flue liner is strongly recommended. - Page 6 This stove must always be fitted with a liner. The baffle plate can be removed to facilitate cleaning through the stove. Hearth, Surround and Register Plate The stove must stand on non-flammable material at least 12mm thick (1/2”). The hearth must extend at least 300mm in front of the firebox and 150mm to the sides.
-
Page 7: Data Plate
Stove Type Flue gas temp down stream of spigot, closed doors. 226C Dartmoor Inset Wood Burning Dartmoor Inset Solid Fuel 220C (Ancit) Flue Gas Mass Flow Stove Types Flue gas mass flow (gs) Dartmoor Inset Wood Burning Dartmoor Inset Solid Fuel (Ancit) Pre –... - Page 8 Fitting of M/F kit for Dean Forge Dartmoor Inset Dean Forge Dartmoor Inset Multi Fuel Parts This M/F kit consists of six parts plus two firebricks A.
- Page 9 Dean Forge Dartmoor 5 Multi Fuel kit Assembled To fit: Open the door and remove the log retainer (on older models),ash retainer and the bolt on the left hand side on the front of the stove near the bottom. Place the main grate (A) into the stove with the leg to the rear of the stove and the front resting in the slots each side at the front of the stove.
-
Page 10: Ec Declaration Of Conformity
EC Declaration Of Conformity The Undersigned, representing the following: Manufacturer Dean Forge Ltd Dean Prior, Buckfastleigh, Devon, TQ11 0LS Herewith declare that the products: Description Product Code Dartmoor 5 STDFDA5, STDFFOH STDFFOL Dartmoor W5 STDFDAW5, STDFHU Dartmoor 6 STDFDA6 Dartmoor 8... - Page 11 Dartmoor 5 Inset- STDFDA5I Co @ 13% 0² Wood 0.35% Ancit 0.40% 6700/1 5Kw @ 83.3% Wood – 4.7Kw @ 73.2% Ancit Dartmoor 5- STDFDA5/ STDFFOH/ STDFFOL Emission of combustible Co @ 13% 0² Wood 0.38% Ancit 0.40% 6931-1 products and Thermal 5Kw @ 81.9% Wood -5Kw @ 70.7% Ancit...
- Page 13 THE DEAN FORGE FABRICATION LTD STOVES GUARANTEE Dean Forge Fabrication Ltd offers a five year guarantee which covers the main body of the stove for manufacturing defects. In the event of any failure we will replace any defective part free of charge, labour cost excluded.
- Page 15 Dean Forge Fabrication Ltd Dean Prior Buckfastleigh Devon TQ11 0LS PRODUCT REGISTRATION Name ......................Address ...............................................................................Phone Number: ..........Suppliers Details: Name ......................Address ...............................................................................Phone Number: ..........Installers Details: Name ......................Address ......................................................................
Need help?
Do you have a question about the Dartmoor 5 and is the answer not in the manual?
Questions and answers