Introduction
Symbols
1
There are specific colored plates on or
near some of the components on your
Maserati designed to attract user's
attention. Important warnings
concerning all specific devices that the
user must consider, are reported on
the internal lid cover central label (see
"Vehicle Identification Data" in this
section).
All symbols reported on the plate and
inside the vehicle, as well as the
component for which the symbols
stand, are summarized in the
following list. These symbols are
divided into categories according to
their meaning.
Danger Symbols
Battery
Corrosive liquid.
Battery
Explosion.
Blower
May start automatically
even with engine off.
14
Coolant expansion
reservoir
Do not open cap with
engine warm.
Coil - headlights
High voltage.
Belts and pulleys
Moving parts, keep body
and clothing clear.
Air-conditioning lines
High pressure gas, do not
open.
Symbols of Prohibitions and
Compulsory Measures
Battery
Keep away from flames.
Battery
Keep out of children's
reach.
Heat guards - belts -
pulleys - fans
Do not touch.
Battery
Wear eye protection.
Battery - jack
Refer to the owner manual.
Warning Symbols
Engine - Engine Oil Filler
Cap
Engine oil. We recommend
using an oil with the
characteristics indicated in
chapter "Refillings" in
Section 8.
Hydraulic steering reservoir
Power steering fluid. Do
not exceed max. level. We
recommend using a liquid
with the characteristics
indicated in chapter
"Refillings" in Section 8.
Brake fluid reservoir
Brake fluid type DOT 4. Do
not exceed max. level. We
recommend using a fluid
with the characteristics
indicated in chapter
"Refillings" in Section 8.
Need help?
Do you have a question about the Ghibli and is the answer not in the manual?
Questions and answers
How do I change the battery of the key?
To change the battery in a Maserati Ghibli key:
1. Remove the key from the fob by pressing the release button.
2. Use a T6 Torx screwdriver to remove the screw at the top of the fob.
3. Carefully pry off the two side aluminum covers using a flat screwdriver.
4. Remove the circuit board by taking out the second screw (also T6).
5. Replace the battery under the circuit board with a CR2032 battery.
6. Reassemble the key fob by reversing the steps.
This answer is automatically generated