Backpack Kit Setup - WAGNER Power Painter Max Owner's Manual

Backpack Kit
Setup
(optional)
Recommended for
Start
medium to large jobs
Note: A 75% duty cycle is recommended when
spraying with the backpack kit. For example,
trigger the gun for 15 seconds, and then allow
the gun to remain idle (untriggered) for 5
seconds.
ImpoRTANT: Avoid running the backpack
dry. An empty backpack will allow air to
get sucked into the sprayer, which leads to
globbing and spitting.
ImpoRTANT: Always make sure the tip nut
is tightened securely prior to spraying.
4
4. Assemble strap hooks to
container using same hole
as lid clip. Adjust strap to
fit user.
1
(a)
1. Lay cord seal (a) in backpack
lid groove (b). Overlap the
ends of the cord seal by
approximately 1/2 inch. Cut off
remaining seal.
Lift seal and butt edges
together and press excess seal
into groove.
5 6
5. If you want to use a
backpack liner, install as
shown.
2
(b)
2. Snap backpack suction tube
(c) through hole in bottom of
backpack lid.
Assemble backpack kit as
shown.
7
(e)
6. Pour material into 7. Place lid on backpack and
backpack to fill line. Do
not fill above the indicated
fill line (e).
7
3
(d)
(c)
3. Secure clip onto suction tube (d).
When backpack kit is
assembled, follow steps 1-5 in
Remote Suction Hose Setup
(previous page) to attach the kit
to the sprayer.
8
(f)
8. Backpack can either be
press firmly into place. back- or shoulder-mounted
Secure with the tabs (f). as shown. Adjust straps to
fit user.
English