Beeper Code Information; Watercraft - Sea-doo GTS Operator's Manual

Gts series; gti series; gtr series; wake series
Hide thumbs Also See for GTS:
Table of Contents

Advertisement

Beeper Code Information

BEEPER CODES
1 long beep
(when installing tether
cord on engine cut-off
switch)
A 2 second beep
every 15 minute interval
A 2 second beep
every 5 minute interval
Continuously beeps
NOTICE
If the monitoring beeper continuously sounds, stop engine as
soon as possible.
Bad D.E.S.S. system connection.
Reinstall tether cord correctly on engine cut-off switcht.
Wrong D.E.S.S. key.
Use a tether cord that has been programmed for the

watercraft.

Defective D.E.S.S. key.
Use another programmed tether cord.
Dried salt water in tether cord cap.
Clean tether cord cap to remove salt water.
Defective engine cut-off switch.
Refer to an authorized Sea-Doo dealer.
Improper operation of ECM or defective wiring
harness.
Refer to an authorized Sea-Doo dealer.
Watercraft is upside down.
Turn watercraft upright. Refer to
Engine management system fault.
Refer to an authorized Sea-Doo dealer.
iBR system fault.
Refer to an authorized Sea-Doo dealer.
Low fuel level.
Refill fuel tank. If problem persists, refer to an authorized
Sea-Doo dealer.
Fuel tank level sensor or circuit malfunction.
Refer to an authorized Sea-Doo dealer.
High engine coolant temperature.
ENGINE OVERHEATING
See
High exhaust temperature.
Refer to an authorized Sea-Doo dealer.
Low oil pressure.
Turn off engine as soon as possible. Check oil level and
refill. Refer to an authorized Sea-Doo dealer.
______________
DESCRIPTION
SPECIAL PROCEDURES
.
MONITORING SYSTEM
143
.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GTS and is the answer not in the manual?

Questions and answers

Table of Contents

Save PDF