Troubleshooting - Blomberg LTS2832W User Manual

8

Troubleshooting

Drying process lasts for a long time.
• Pores of the fibre filter might be clogged. >>> Wash the filter with warm water.
• Condenser might be clogged. >>> Wash the condenser.
• Ventilation grills at the front of machine might be blocked. >>> Remove any items in front of the ventilation
grills that block ventilation.
• Ventilation might be inadequate if the installation area is very small. >>> Open the windows and doors in
order to prevent excessive increase in room temperature.
• There might be furring on the damp sensor. >>> Clean the damp sensor.
• Laundry might be overloaded. >>> Do not overload the tumble drier.
• Laundry might not have been adequately spun. >>> Increase the rpm of tumble drier.
Laundry is still wet at the end of drying.
C
Hot laundry unloaded at the end of drying feel wetter than they really are.
• You may not have used a programme suitable for laundry type.>>> Check the maintenance labels on the
laundry and select a programme suitable for their type, or use the time programmes additionally.
• Pores of the fibre filter might be clogged. >>> Wash the filter with warm water.
• Condenser might be clogged. >>> Wash the condenser.
• Laundry might be overloaded. >>> Do not overload the tumble drier.
• Laundry might not have been adequately spun. >>> Increase the rpm of tumble drier.
Tumble drier does not turn on or programme cannot be started. Tumble drier does not activate when set.
• The power cord might not be plugged in. >>> Make sure the power cord is plugged in.
• Loading door might be open. >>> Make sure that the loading door is properly closed.
• You may not have set the programme or pressed the Start/Pause button. >>> Make sure that you have set
the programme and it is not in Pause position.
• Child lock might be active. >>> Disable the child lock.
Programme was interrupted for no reason.
• Loading door might not be properly closed. >>> Make sure that the loading door is properly closed.
• A power cut might have occurred. >>> Press the Start/ Pause button to start the programme.
• Water tank might be full. >>> Drain the water tank.
Laundry is shrunk, damaged or worn out.
• You may not have used a programme suitable for laundry type. >>> Check the maintenance labels on the
laundry and select a programme suitable for their type.
The lighting inside the tumble drier does not turn on. (In models with lamps)
• You may not have turned on the tumble drier be using On/Off/Cancel button. >>> Make sure that the tumble
drier is at 'on' position.
• Lamp might be broken. >>> Contact the Authorised Service for the replacement of lamp.
Filter cleaning warning led is on.
• Fibre filter might not have been cleaned. >>> Clean the filter.
Filter cleaning warning led flashes.
• Filter bearing might be clogged with fibre. >>> Clean the filter bearing.
• There might be a layer in the filter pores that causes clogging. >>> Wash the filter with warm water.
• Condenser might be clogged. >>> Wash the condenser.
Water is leaking from the condenser cover.
• There might be fibre build-up inside the loading door and on the surfaces of loading door gasket. >>> Clean
the inner surfaces of loading door and surfaces of loading door gasket.
Dryer / User Manual
EN 31 / 36