Panasonic CQ-DVR592U Operating Instructions Manual page 26

Troubleshooting
Common (continued)
E
Trouble
N
G
L A mobile phone is used near the unit.
Noise.
I
Keep the mobile phone away from the unit.
S
H
Radio
35
Trouble
Station is too far, or signals are too weak.
Select other stations of higher signal level.
The motor antenna relay control lead is not connected correctly.
Too much noise in FM
If there is a motor antenna in the car, connect the motor antenna
stereo and monaural
relay control lead to the motor antenna lead that is installed in the
broadcasts.
car correctly.
The radio antenna is not extended enough.
Extend fully the radio antenna.
Battery cable is not correctly connected.
Preset station is reset.
Connect the battery cable to the terminal that is always active.
DVD/Video CD/CD
Trouble
Disc is upside down.
Place disc in the correct direction with the label side up.
Disc is dirty, or has scratches.
Clean disc or change disc, referring to the section on "Notes on Disc".
The unit can only play the following types of discs: DVD video, Video
CD, CD and CD-DA data recorded CD-R and CD-RW, and MP3 data
recorded CD media (CD-ROM, CD-R, CD-RW).
The disc is inside but no
sound.
The unit may not successfully play back a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive)
and a disc which are incompatible one another. Refer to
instructions for the concerned devices for details.
You are trying to play a dts CD or DVD.
The player cannot play audio on dts CDs or DVDs unless a digital surround
processor is used (
50
CQ-DVR592U
(continued)
Cause/Step
Cause/Step
Cause/Step
pages 72–73).
DVD/Video CD/CD (continued)
Trouble
Disc is dirty, or has scratches.
Clean disc or change disc, referring to the section on "Notes on Disc".
Sound skips, bad sound
The unit may not successfully play back a CD-R/RW that was made
quality. (e. g. caused by
by the combination of writing software, a CD recorder (CD-R/RW
noise)
drive) and a disc if they are incompatible one another. Refer to
instructions for the concerned devices for details.
Mounting angle is over 30x.
Adjust mounting angle to less than 30x.
Sound skips due to
Unstable mounting.
vibration.
Mount the unit securely with the mounting parts, referring to the
section on installation.
Disc is defective.
≥
Mechanical trouble.
≥
Disc is not ejected.
Open the panel and press [<] (eject). If the disc still does not eject,
press the reset switch. (
Disc is dirty, or has scratches.
CD text is not displayed
Clean disc, referring to the section on "Notes on Disc".
normally.
The first track of a mix mode disc was reproduced. (Mix mode is a
Time is counted but no format in which data except music is recorded on the first track and
sound comes out. music data is recorded on other than the first track in a session. )
Play back music data recorded on other than the first track.
Condensation (dew).
≥
The disc will not play, or
Wait for a while before use.
else it stops very
Disc is dirty, or has scratches.
≥
quickly.
Clean disc or change disc, referring to the section on "Notes on Disc".
Cables are not correctly connected.
The picture does not Connect cables correctly.
appear on the monitor. Check the settings for the monitor itself.
Stop the car and apply the parking brake.
Some operations are not permitted with certain discs.
The buttons do not work.
Refer to the guide provided with your disc.
Video CD menu playback Menu playback is only possible when playing a video CD that has
does not work. the playback control feature.
E
Cause/Step
N
G
L
I
S
H
36
page 54)
51
CQ-DVR592U