Fuser Removal; Induction Heater Removal - Lexmark MX910de Service Manual

Fuser removal

1
Open the right door.
2
Remove the three screws (A). Remove the fuser connector cover, and then disconnect the three fuser cables (B).
3
Remove the fuser.
Note: If the fuser rollers are not retracted, the fuser may be hard to remove. To retract the fuser roller, turn on
the printer to initiate warm‑up, and then turn off the printer.

Induction heater removal

1
Remove the scanner interface cable cover. See
2
Remove the controller board access cover. See
3
Remove the engine board cover. See
4
Remove the upper rear cover. See
5
Remove the induction heater power supply shield. See
6
Remove the fuser. See
7
Remove the left cover. See
8
Remove the standard bin base. See
"Scanner interface cable cover removal" on page
"Controller board access cover removal" on page
"Engine board cover removal" on page
"Upper rear cover removal" on page
"Fuser removal" on page
"Left cover removal" on page
"Standard bin base removal" on page
Repair information
346.
"IHPS shield removal" on page
279.
272.
279
344.
345.
346.
347.
389.
7421