Advertisement
Thank
you for your purchase
of the Sanyo
Vacuum
Cleaner.
Please read these instructions
carefully
before
using.
A FEW PRECAUTIONS
1. Operating without
the filter in place will allow dust to enter the motor
and could damage the vacuum cleaner.
2.
Keep the vacuum
cleaner away from stoves and other heat sources.
Heat can deform and discolor the plastic parts of the unit.
3. Keep
the
vacuum
cleaner
free
of insecticides.
Do not wipe with
benzine, thinner,
petrol or other oils which might cause discoloration
or cracking. To clean the body and hose, dampen a cloth with a mild
detergent and wipe clean.
5, Be sure not to push the clamp
button
while carrying
the vacuum
cleaner.
6. Never try to vacuum the following objects. They may damage the unit
or cause a fire.
Wet things, mud, soil, and fluids
Burning cigarettes
*Needles and razor blades
"Inflammable
materials such as gasoline and thinner
7, The following
kinds of treatment
shorten hose life:
*Bending hose at an acute angle when storing
*Pulling the hose with excessive force
"Placing heavy objects on, or stepping on the hose
8. Pull out the plug from the power source after use, GrasR the plug -
not the cord – when pulling out the plug.
Pulling on the cord may lead to shortcircuiting.
9. Long and continuous
use causes the exhaust air and the body of the
vacuum
cleaner to become
warm.
This, however,
does not denote
malfunction.
10t When vacuuming
vinyl
mats which may stick to the floor
nozzle
because of the suction, lift up the rear of the floor nozzle slightly by
moving
the wands close to a vertical
position.
11, When vacuuming places that are very dusty, and also when vacuuming
regularly,
empty the dust compartment
before it becomes completely
filled.
Frequent
emptying
lengthens
the life of the motor
and maintains
strong suction power.
12. (For Australia only)
If the supply
cord of this appliance
is
replaced
by a repair shop appointed
by
special purpose tool are required.
CARE
AND MAINTENANCE
damaged,
it must
the manufacturer,
only be
because
When you have trouble
with the unit, inspect it according to the points in
the
"Trouble-Shooting
Guide"
If
inspection
indicates
a malfunction,
refrain
from
using the unit to avoid damage, and see your dealer or the
nearest Sanyo Service Centre.
Trouble-Shooting
Guide
$ymptam
Itomo te Ingpaet
ISthe
filter dirty7
Suction does not get
Clean the filter.
stronger after cleaning out
the dirt. (Weak suction)
IS the floor nozzle or the hose clogged with a
large object?
Push it out with a garden hose.
Motor does not run con-
.
IS
the
cord
damaged
where it is connected to the
tenuously. (Motor starts and
plug, or are you pulling on the cord too hard or
bending it.
stops)
Change the cord.
IS the cord twisted
or wound
uneven on the
The cord does not go back
roller?
fully into the unit.
Pull the cord out 1-2m and try rewinding it
again.
SPARE CARBON
BRUSH
The carbon brush is an important
part of the motor section of the vacuum
cleaner. Although the time will differ according to usage, the carbon brush
will
deteriorate after a long period, This deterioration decreases the
revolutions
of the motor,
causes noisy operation and shortens service life.
It should be replaced after about the third year of use,
Carbon brushes can be replaced at your nearest Sanyo Service Centre.
Advertisement
