Table of Contents
Advertisement
English
1. AC/DC power adaptor
1
2. Auxiliary jack (3.5 mm)
3. USB power/charging port
4. Top compartment cover
Figure 3. Top Compartment
1. Battery pack (not included)
2. Battery pack receptacle
3. Battery pack cover
1
Figure 4. Battery Compartment
1. LCD Display
• Audio source
• Reception (radio mode)
• Bluetooth (Bluetooth mode)
1
• Battery status
2. Radio preset buttons
3. Selection dial
4. Mode buttons
• Power On/Off (
)
• Source selection (
)
• Back (
)
• Bluetooth (
)
Figure 5. Control Panel
10
2
3
4
2
3
2
3
4
CHARGING
The DWST08810 can charge only
DEWALT DCB series 12VDC/20VDC Li-ion
rechargeable battery packs with 5Ah max.
Use of any other battery packs or any non-
rechargeable batteries may create a risk
of injury or fire. Be sure to read all safety
instructions before using this appliance for
charging your battery pack.
IMPORTANT CHARGING NOTES
1.
Longest life and best performance can
be obtained if the battery pack 1. is
charged when the air temperature is
between 65 °F and 75 °F (18–24 °C).
DO NOT charge the battery pack in an
air temperature below +40 °F
(+4.5 °C), or above +105 °F (+40.5 °C).
This is important and will prevent serious
damage to the battery pack.
2.
The charger and battery pack may
become warm to the touch while
charging. This is a normal condition, and
does not indicate a problem. To facilitate
the cooling of the battery pack after
use, avoid placing the charger or battery
pack in a warm environment such as in a
metal shed or an uninsulated trailer.
3.
A cold battery pack will charge at about
half the rate of a warm battery pack. The
battery pack will charge at that slower
rate throughout the entire charging cycle
and will not return to maximum charge
rate even if the battery pack warms.
4.
If the battery pack does not charge
properly:
a. Check operation of receptacle by
plugging in a lamp or other appliance;
b. Check to see if receptacle is
connected to a light switch which turns
power off when you turn out the lights;
c. Move the charger and battery pack
to a location where the surrounding air
temperature is approximately 65–75 °F
(18–24 °C);
d. If charging problems persist, take the
battery pack and charger to your local
service center.
5.
The battery pack should be recharged
when it fails to produce sufficient
power on jobs which were easily done
previously. DO NOT CONTINUE to use
the pack under these conditions. You
English
may also charge a partially used pack
with no adverse effect on the battery
pack.
6.
Foreign materials of a conductive nature
such as, but not limited to, grinding
dust, metal chips, steel wool, aluminum
foil, or any buildup of metallic particles
should be kept away from charger
cavities. Always unplug the charger from
the power supply before attempting to
clean.
7.
DO NOT freeze or immerse the charger
in water or any other liquid.
WARNING: Shock hazard. Don't
allow any liquid to get inside the
charger. Electric shock may result.
WARNING: Burn hazard. DO NOT
submerge the battery pack in any liquid
or allow any liquid to enter the battery
pack. NEVER attempt to open the
battery pack for any reason.
If the plastic housing of the battery pack
breaks or cracks, return to a service
center for recycling.
CAUTION: Danger of explosion if
battery is incorrectly replaced.
Replace only with the
same or equivalent type.
STORAGE RECOMMENDATIONS
1.
The best storage place is one that is
cool and dry, away from direct sunlight
and excess heat or cold.
2.
For long-term storage, it is
recommended to store a fully charged
battery pack in a cool dry place out of
the charger for optimal results.
NOTE: Battery packs should not be
stored completely depleted of charge.
The battery pack will need to be
recharged before use.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
11
Hide quick links:
Advertisement
Table of Contents
