11.6 Disassembly and Replacement
11.6.1
Developer unit
Notes:
•
Make sure to perform "05-280" and take off the process unit before the developer material is
replaced.
•
When installing the developer unit, make sure that the harness on the upper side of the unit
does not touch the equipment.
•
When installing the developer unit, make sure that the harness on the front side is not caught
in the drawer.
(1)
Take off the Process unit.
P.10-9 "10.7.1 Process unit"
(2)
Take off the drum cleaner unit from the
process unit so that only the developer unit
will be left.
P.10-11 "10.7.2 Drum cleaner unit"
Notes:
1. Be careful not to touch or scratch the
drum surface at this time.
2. Do not deform the Guide Mylar by
touching this.
© 2009 TOSHIBA TEC CORPORATION All rights reserved
Drum cleaner unit
Fig. 11-6
Fig. 11-7
11 - 11
Developer unit
Guide mylar
e-STUDIO182/212/242
DEVELOPMENT SYSTEM
11