Table of Contents
Advertisement
_________________________________________________________________________________________________________
ASSEMBLY & OPERATING INSTRUCTIONS
MODEL # 48038
4 Burner Stainless Steel, Rotisserie, Built-In, L.P. (Propane)
MODEL # 48039
Burner Stainless Steel, Rotisserie, Built-In, Natural Gas
TABLE OF CONTENTS
SAFETY INSTRUCTIONS ..............................................................................................................
INSTALLATION INSTRUCTIONS .....................................................................................................
LIGHTING & OPERATING INSTRUCTIONS ........................................................................................
CLEANING & MAINTENANCE ..........................................................................................................
TROUBLESHOOTING ....................................................................................................................
PARTS LIST .................................................................................................................................
WARRANTY...................................................................................................................................
READ THE FOLLOWING INSTRUCTIONS CAREFULLY AND BE SURE YOUR GRILL IS PROPERLY INSTALLED, ASSEMBLED
AND CARED FOR. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN SERIOUS BODILY INJURY AND/OR
PROPERTY DAMAGE. IF YOU HAVE QUESTIONS CONCERNING ASSEMBLY OR OPERATION, CONSULT YOUR DEALER,
GAS APPLIANCE SERVICE REPRESENTATIVE OR YOUR GAS COMPANY
NOTE TO INSTALLER:
LEAVE THESE INSTRUCTIONS WITH THE CONSUMER AFTER INSTALLATION.
NOTE TO THE CONSUMER
RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
THIS OUTDOOR COOKING GAS APPLIANCE IS NOT INTENDED TO BE INSTALLED IN OR ON RECREATIONAL VEHICLES
AND/OR BOATS.
BY BULL MANUFACTURING
Rialto , California 92376
1
PAGE
2
4
9
14
15
16
18
Revision 11/08
Advertisement
Table of Contents
Related Manuals for Bullet Barbecue 48038
Summary of Contents for Bullet Barbecue 48038
-
Page 1: Table Of Contents
BY BULL MANUFACTURING Rialto , California 92376 _________________________________________________________________________________________________________ ASSEMBLY & OPERATING INSTRUCTIONS MODEL # 48038 4 Burner Stainless Steel, Rotisserie, Built-In, L.P. (Propane) MODEL # 48039 Burner Stainless Steel, Rotisserie, Built-In, Natural Gas TABLE OF CONTENTS PAGE SAFETY INSTRUCTIONS ………………………………………………………………………………..………………... -
Page 2: Safety Instructions
SAFETY INSTRUCTIONS Read carefully before assembling and operating your gas grill This gas grill must be installed in accordance with local codes or, if in an area without local codes, with the latest edition of the National Fuel Gas Code ANSI Z223.1. In Canada, installation must conform to the standard CAN/ CGA 1-b149.1 and/or .2 (Installation Code for Gas Burning Appliances and Equipment) and any local codes. -
Page 3: Natural Gas Safety
NATURAL GAS SAFETY Your Natural Gas grill is designed to operate on natural gas ONLY, at a pressure of 4” water column (W.C.) regulated at the natural gas regulator attached at the back of the grill. Check with your gas utility for local gas pressure and with your local municipality for building code requirements. -
Page 4: Installation Instructions
INSTALLATION INSTRUCTIONS PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLING YOUR GAS GRILL Your Built-in Gas Grill comes to you fully assembled. We strongly recommend professional installation and hookup of the Gas BBQ grill. These instructions will provide you with the measurements necessary for you or your builder to construct a masonry structure to house your outdoor gas grill. - Page 5 OUTDOORS NATURAL GAS BBQ INSTALLATION SPECIFICATIONS NOTE: Vents must be provided for combustion air on both sides of built-in cabinet. When choosing a location for your gas grill keep in mind that it should never be located under any overhead combustible construction.
- Page 6 OUTDOORS PROPANE GAS BBQ INSTALLATION SPECIFICATIONS NOTE: Vents must be provided for combustion air on both sides of built-in cabinet. When choosing a location for your gas grill keep in mind that it should never be located under any overhead combustible construction.
- Page 7 BURNER CLEANING 1. Remove burner from the grill bowl (See drawing on right). Bend a stiff wire (a light-weight coat hanger works well) into a small hook as shown below. Run the hook through each burner tube and burner several times. 2.
-
Page 8: Lighting & Operating Instructions
IMPORTANT: Before first use wash flame tamers, cooking grids, and warming rack with warm, soapy water. Rinse and dry thoroughly. Season metal surfaces with cooking oil occasionally. (After cooking is completed, turn grill to high setting for NO MORE THAN five minutes to burn off excess grease or food residue) CAUTION: DO NOT LEAVE GRILL UNATTENDED. - Page 9 1. Become familiar with safety guidelines at front of manual. DO NOT SMOKE WHILE LIGHTING GRILL OR CHECKING GAS SUPPLY CONNECTIONSI 2. If your grill fuel source is a LP gas cylinder, check to see that cylinder is filled. 3. Check the end of each burner tube to make sure it is properly located over each valve orifice. 4.
- Page 10 CAUTION: DO NOT LEAVE GRILL UNATTENDED. Preheating: It is necessary to preheat the grill for a short time before cooking certain foods, depending on the type of food and the cooking temperature. Food that requires a high cooking temperature needs preheat for five minutes; food that requires a lower cooking temperature needs only a period of two to three minutes.
-
Page 11: Cleaning & Maintenance
to 4½ hrs to cook depending on the size and type of meat being cooked. You can have rotisserie cooking with indirect heat as shown or with an infrared rotisserie burner. For successful rotisserie, the meat should be centered and balanced as evenly as possible on the spit rod to avoid overworking the rotisserie motor.(see rotisserie kit assembly shown below) Since indirect heat is often used in cooking on a rotisserie, a foil or aluminum... -
Page 12: Troubleshooting
Washing the flame tamer after every use is not necessary but periodically it is suggested you wash the tamer in a soap and warm water solution. Use a wire brush to remove stubborn burned on cooking residue. Dry the flame tamer thoroughly before you reinstall it in the cooking bowl. -
Page 13: Parts List
b. Obstruction in gas line CORRECTION: Remove fuel line from grill. DO NOT SMOKEI Open gas supply for one second to blow any obstruction from fuel line. Close off gas supply at source and reconnect fuel line to grill. c. Plugged orifice CORRECTION: Remove cooking grids, flame tamers, grease draining tray. -
Page 14: Illustrated Parts List
REF# DESCRIPTION STANDARD INFRARED LID-FRONT LID-REAR COVER-REAR LID ASSEMBLY CONTROL PANEL GREASE TRAY GREASE TRAY HANDLE HEAT SHIELD CAST- BURNER STAINLESS STEEL BURNER FLAME TAMER COOKING GRID WARMING RACK LID HANDLE WARMING RACK SUPPORT FLAME TAMER SUPPORT BEZEL-MAIN BURNER BEZEL- BACK BURNER KNOB-MAIN BURNER KNOB-BACK BURNER TEMPERATURE GAUGE... -
Page 16: Limited Warranty
BY BULL MANUFACTURING Rialto , California 92376 LIMITED WARRANTY Bull Outdoor Products, Inc. warrants to the original purchaser at the original site of delivery with proof of purchase of each Outdoor Gas Grill that when subject to normal residential use, it is free from defects in workmanship and materials for the periods specified below.
Need help?
Do you have a question about the 48038 and is the answer not in the manual?
Questions and answers