Table of Contents
Advertisement
DO
DO NOT
• Attach swing arm and upright
assembly as shown (STEP 1).
• Pull back on Auto Pin to engage in
receiver hole. Use knob to tighten.
Lock (STEP 3).
• Load heaviest bike first - front to
the right (STEP 7).
• Alternate bike direction.
• Secure bicycle to rack with rubber
straps and black safety strap
through the frames and around
the mast of the rack (STEP 9).
• Check tightness of all bolts
and knobs periodically
(every 6 months).
• Check rubber straps for wear
and replace if worn.
• Install on a trailer or other towed
vehicle.
• Put more than 2 bikes on a class
1 hitch.
• Do not "overstretch" the straps.
• Use the rack while traveling on dirt
roads.
• Use the rack to carry tandems or
recumbents.
• Put more than the intended number
of bikes on the rack.
QUICK START GUIDE for:
APEX SWING AWAY
9027
Advertisement
Table of Contents
Related Manuals for Thule 9027
Summary of Contents for Thule 9027
- Page 1 9027 QUICK START GUIDE for: APEX SWING AWAY • Attach swing arm and upright assembly as shown (STEP 1). • Pull back on Auto Pin to engage in receiver hole. Use knob to tighten. Lock (STEP 3). • Load heaviest bike first - front to the right (STEP 7).
- Page 2 APEX SWING AWAY 9027 PARTS INCLUDED part description part number qty. — Apex Swing Bike Carrier / cradle overmold / 8523503001 swing arm assembly / — 753190902 M8 lock knob / 8523134001 Apex 2” hitch adaptor / 1/2" lock nut /...
- Page 3 • Number of bicycles should not exceed designated carrying capacity for your specific Apex Swing Away. • 9027 (4 bike) max carrying capacity = 140 lbs. • Check tightness of all bolts and knobs periodically. • Check straps for wear and replace if worn.
- Page 4 STINGER INSTALLATION / FOR 2" RECEIVERS ATTACH 2" ADAPTER • Attach carrier to receiver by pulling back gently on Auto Pin while sliding stinger into receiver. • Using hex key attach adapter sleeve to stinger with two M8 x 30 flat head screws. •...
- Page 5 • Attach anti-sway angled extension to underside of cradles 1 and 4 as illustrated. • Load heaviest bike first onto the inner most cradles - handle bars facing passenger side of vehicle. • Fasten cradle straps. • Use Thule Frame Adaptor (#982XT, sold separately) for bikes without traditional top tubes.
- Page 6 ATTACHING HOLD FAST ANTI-SWAY CAGES • To attach anti-sway cage, hold horizontal with smooth edge facing down and slide C-slot opening onto Anti-Sway Extension / Cradle. Swing down to vertical position. Place smooth curved surface against bicycle and attach strap as shown. •...
- Page 7 OPENING CARRIER / • Insert hold-open pin into locking position when fully open to prevent carrier from swinging closed. hold-open pin CLOSING CARRIER / lock-up pin lower locking handle • Pull Lock-up pin to release upper arm assemby and • Close carrier. Lock-up pin will click into WARNING: Before operating rotate bike arms to stop position.
- Page 8 SECURITY INSTALLING END CAP LOCK CORE • Install lock cylinder into locking end cap with Change Key. USING LOCKING CABLE / • Lock bikes to carrier with cable lock.
Need help?
Do you have a question about the 9027 and is the answer not in the manual?
Questions and answers