Replacing The Camber Tube - Ti Lite TR Series 1 Owner's Manual

I WARNING
The threads on the Hex bolts that secure the Frog Legs
a medium strength thread lock. If you loosen any Hex bolt, you MUST remove and reapply Loctite
equivalent medium strength thread lock. If you ignore this Warning, your Frog Legs
or fall off and you could fall, tip over or lose control of the wheelchair and seriously injure yourself or others or damage
the wheelchair.

Replacing the Camber Tube

Tools Needed:
• 5/32" Allen Wrench
1. Remove the rear wheels.
2. Loosen but do not remove the Allen screw that secures the camber tube to each Frog Legs
Figure 8-7.
3. Remove the camber tube.
Note: If your camber is 12°, 15° or 18°, you will need to remove the axle sleeve to allow the camber tube to slide
out of the clamp or mount, see "Adjusting Rear Wheel Spacing" on page 12-3.
4. Install the new camber tube, making sure the distance from the outside edge of the Frog Legs
end of the camber tube is identical on both sides of the chair.
5. Make sure that the camber plug flats are perpendicular to the ground and that the camber is oriented properly
(wheel base wider at the bottom than the top).
6. Securely tighten both Allen screws.
7. Reinstall the rear wheels.
8. Check the toe-in/toe-out and adjust as needed.
Adjusting Toe-In/Toe-Out
Tools Needed:
• 3/16" Allen Wrench
• 7/8" Open End Wrench
• Ruler or Tape Measure
Note: Adjusting toe-in/toe-out does not apply to chairs with 0º camber; however, it is still necessary to make sure that
the camber plug flats are perpendicular to the ground and the axle sleeve is located at the uppermost part of the plug..
1. Make sure the distance from the end of the camber tube to the camber clamp is identical on both sides of the
chair. See Figure 8-8.
2. Make sure the rear wheels are properly inflated.
3. Place the chair on all four wheels with the casters trailing toward the rear of the frame. See Figure 8-9.
Figure 8-8
Adjusting the Toe-In/Toe-Out
Camber Clamp
TR/YR Owners Manual
CHAPTER 8: AXLE PLATES AND CAMBER PLUGS
(CENTER OF GRAVITY; REAR SEAT HEIGHT)
Suspension to the frame are treated with Loctite
®
Camber Tube
Measurement A
8-5
Suspension could become loose
®
Suspension. See
®
Figure 8-9
Adjusting the Toe-In/Toe-Out
242 ,
® ®
242 or an
® ®
Suspension to the
®
OM_TR_0712RevC