Sanyo SBM-20 Service Manual page 19

(20) By removing
(Fig. 5)
the 2 hindge fitting screws, the hinge and reinforcement can be dismounted from
,=
Tapping screw, pan hd. 4 x 8mm
Hinge
Reinforcement
Enclosure
(Fig. 5)
enclosure.
Precautions for Reassembly
1.
When mounting the power supply cord, the cord bushing should be attached to the cord holder so that the
dimension between the bushing and the exit of the lead wire is approx. 20 mm. (Fig. 6)
For wiring of the terminal section, see Fig.6.
Lead wire 105L
Ground
(greenly
(Fig. 6)
2. When mounting the belt, the belt is hooked on the pulley (small) is hooked partially from the lower side of
the pulley (big). The belt is wrapped on the pulley (big) by turning on the pulley (big) . (Fig. 7)
Pulley
ame
Pulley (small)
Belt
(Fig. 7)
18