System; Midi - Boss DD-500 Owner's Manual

SYSTEM

Parameter
CONTRAST
OUTPUT
BANK MODE
BANK EXTENT MIN
BANK EXTENT MAX
KNOB LOCK
KNOB MODE
BYPASS
PEDAL ACT
FSW HOLD TIME
FSW MODE
USB MODE
LOOP MODE

MIDI

Parameter
Rx CHANNEL
Tx CHANNEL
PC IN
PC OUT
CC IN
CC OUT
TIME CONTROL
A SW CC
B SW CC
TAP/CTL SW CC
FEEDBACK CC
E. LEVEL CC
TONE CC
MOD DEPTH CC
CTL1 CC
CTL2 CC
EXP CC
EFFECT ON/OFF CC
LOOP ON/OFF CC
LOOP REC/DUB CC
LOOP PLAY CC
LOOP STOP CC
LOOP CLEAR CC
SYNC
REALTIME SRC
MIDI IN->OUT
USB IN->OUT
DEVICE ID
Explanation
Adjusting the contrast of the display
Selects how output occurs.
Specifies the timing at which the patch is changed when you change banks.
Sets the lower limit for the banks.
Sets the upper limit for the banks.
Specifies whether knob operations will be disabled.
Specifies how knob operations occur.
Specifies how the bypass sound is output.
Specifies whether the operation occurs when you press the [A], [B], or [TAP/CTL] switch or when you release
the switch.
Specifies the number of seconds of holding down the [A], [B], or [TAP/CTL] switch that is interpreted as a
long-press.
Specifies how the footswitch is used (p. 19).
Specifies the USB operating mode (p. 21).
Specifies the sampling frequency.
Explanation
Specifies the receive channel.
Specifies the transmit channel.
Specifies whether program changes are received.
Specifies whether program changes are transmitted.
Specifies whether control changes are received.
Specifies whether control changes are transmitted.
Specifies whether operations of the [TIME/VALUE] knob are transmitted and received.
[A] switch
[B] switch
[TAP/CTL] switch
[FEEDBACK] knob
[E. LEVEL] knob
Specifies the controller number of the corresponding knobs or switches.
[TONE] knob
[MOD DEPTH] knob
External CTL1 switch
External CTL2 switch
External EXP pedal
Specifies the controller number that switches between delay-on and bypass.
Specifies the controller number that switches the phrase loop function on/off.
Specifies the controller number that executes recording or overdubbing when using the phrase loop
function.
Specifies the controller number that executes loop playback when using the phrase loop function.
Specifies the controller number that stops playback when using the phrase loop function.
Specifies the controller number that clears the phrase when using the phrase loop function.
Selects the tempo clock input that is used for synchronization.
Selects the source of the realtime messages that are transmitted from the MIDI OUT connector or the USB
port.
Specifies the connector to which MIDI messages received from the MIDI IN connector are output.
Specifies the connector to which MIDI messages received from the USB port are output.
Sets the MIDI Device ID used for transmitting and receiving System Exclusive messages.
Parameter List
17