Refueling - NorthStar M296026C Owner's Manual

NOT CORRECT
WARNING:
Stop engine and set brake before leaving operator's position. KEEP BRAKE
ENGAGED except when changing locations.
7. When finished, stop the machine.
8. Pull machine away from stump, and rake chips away from stump.
1) Before removing gas cap, turn engine off and allow to cool for at least two minutes.
Note: A running or hot engine can ignite fuel.
2) Remove grinder gasoline cap.
3) Add gasoline through the fill opening:
- Use only an UL-approved portable gasoline container to transfer
the gasoline to the grinder's tank.
- Be aware of safety warning and instructions below for avoiding
static electric caused fires.
- Do not overfill.
WARNING:
Static electric spark hazard
A static electric spark can explosively ignite gasoline vapor, resulting
in a flash fire that could cause serious injury or death. See "Special
Safety Information on Static Electricity" at end of this manual.
4) Clean up gasoline spills /splashes immediately.
 If possible, move the grinder away from spilled gasoline on the ground.
 Wipe up spilled gasoline, and wait 5 minutes for excess gasoline to evaporate before starting
engine.
 Gasoline soaked rags are flammable and should be disposed of properly.
Operation
Wheel

5. Refueling

15
CORRECT
Chip pile/debris
Hole