» Do not put any object into open- » Do not expose to rain, store ings. Do not use with any opening » Use only BISSELL cleaning indoors. blocked; keep openings free of products intended for use »...
Additional tools may vary – Base Unit check carton for contents. Thanks for buying a BISSELL deep cleaner We’re glad you purchased a BISSELL Safety Instructions... 2 deep cleaner. Everything we know about floor care went into the design Product View.
Formula & Recline Pedal Water Tank Cord Clip Water Tank Pedal Cord Clip Formula & Formula & Water Tank Dirty Water Water Tank Dirty Water Tank Tank Dirty Water Dirty Water Tank Tank EdgeSweep® EdgeSweep® Brushes Brushes www.BISSELL.com EdgeSweep® EdgeSweep®...
Store an attachment on the end of the hose. Make sure hose is wrapped. Since attachments vary by model, see carton Rotate the latch to lock for which attachments are included. into place. www.BISSELL.com...
Cleaning Formulas WARNING To reduce the risk of fire and electric shock due to internal component damage, use only BISSELL cleaning fluids intended for use with the deep cleaner. Keep plenty of genuine BISSELL 2X* Always use genuine BISSELL deep formula on hand so you can clean and cleaning formulas.
• Add 1.5 oz of any BISSELL Boost NOTE: Fill with hot (140°F/60°C MAX) tap water and add the appropriate BISSELL solution. DO NOT HEAT WATER OR TANK IN MICROWAVE, OR USE BOILING WATER. Do not substitute BISSELL 2X Formula cleaning solution with other household cleaning products.
Page 8
If that occurs, unplug your machine, remove the foreign object, and plug the unit back to reset circuit breaker. ATTENTION: Some Berber carpets have a tendency to fuzz with wear. Repeated strokes in the same area with an ordinary vacuum or deep cleaner may aggravate this condition. www.BISSELL.com...
Page 9
• When cleaning stairs, avoid tripping by placing the Pod on same step on which you are standing or seated. • Work your way down the stairs, moving the Pod when required. • Always be aware of where the unit is plugged into the outlet and avoid entanglement. www.BISSELL.com...
NOTE: CLEAN THE MACHINE BEFORE STORING. Fill the Formula & Water Tank with hot tap water and turn on unit. Refer to section Maintenance: Cleaning Machine After Use (page 11) for further details. www.BISSELL.com...
Page 11
Pivot into place Insert Tabs into slots Wipe out the end caps with a Rinse and replace clear Brush Covers, clean paper towel carefully aligning top cover tabs along front slots of bottom cover www.BISSELL.com...
Page 12
Small Belt Pivot Arm Small Belt Roller Remove the only screw holding pivot Replace the small belt before reversing arm, gently pull off arm to expose ends steps to reassemble pivot arm and of the brush rolls. end cap. www.BISSELL.com...
Page 13
(see above). Remove the only screw holding pivot arm, gently pull off arm with attached rods. Replace large belt or brush rolls, as required, carefully reassembling the brush rolls and pivot arm with attached rods and secure the pivot arm with the screw. www.BISSELL.com...
Formula & water tank is empty Check fluid levels in formula & water tank Suction Gate is open Check to make sure the suction gate is closed. Follow “Cleaning Suction Gate” instructions on page 10, step 3. www.BISSELL.com...
Service If your BISSELL product should require service: Contact BISSELL Consumer Care to locate a BISSELL Authorized Service Center in your area. If you need information about repairs or replacement parts, or if you have questions about your warranty, contact BISSELL Consumer Care.
Need help?
Do you have a question about the PROHEAT 2X LIFT-OFF 30K7 Series and is the answer not in the manual?
Questions and answers