Basic Speaker Configuration - Yamaha CX-A5100 Owner's Manual

1 2 3 4 5 6 7 8 9 10 11 12

Basic speaker configuration

■
Placing speakers in your room
Depending on the number of speakers, place the speakers and subwoofer in your room. This section describes the representative speaker layout examples.
• To play back Dolby Atmos contents, apply a speaker system with a ★ mark.
• (About the number of channels) For example, "5.1.2" denotes "standard 5.1-channel plus 2 for overhead
speaker channels". For details on how to place overhead speakers (presence speakers), see "Presence
speaker layout" (p.26).
❑ 11.2-channel system [★7.1.4]
E
1
9
4
T
6
This speaker system brings out the full performance of the unit and allows you to enjoy
a highly-natural 3-dimensional sound field with any contents.
• When Zone3 output is enabled (p.100), the rear presence left/right channel output is not available in the
main zone.
• When using front presence and rear presence speakers installed to the ceiling or when using the Dolby
Enabled speakers as the presence speakers, configure the "Layout (Front Presence/Rear Presence)"
setting in the "Setup" menu before performing YPAO (p.44).
R
2
3 9
5
Y
7
❑ 9.2-channel system [★5.1.4] (using rear presence speakers)
E
4
T
This speaker system uses the front and rear presence speakers to produce a
highly-natural 3-dimensional sound field, and also creates Virtual Surround Back Speaker
(VSBS) using the surround speakers to add a sense of depth to the rear sound field. This
system is suited for enjoying not only 5.1-channel but also for 7.1-channel contents.
• When Zone3 output is enabled (p.100), the rear presence right/left channel output is not available in the
main zone.
• When using front presence and rear presence speakers installed to the ceiling or when using the Dolby
Enabled speakers as the presence speakers, configure the "Layout (Front Presence/Rear Presence)"
setting in the "Setup" menu before performing YPAO (p.44).
22
En
R
1 2
9 3 9
5
Y