Mitsubishi Electric LT-40133 Owner's Manual page 58

58
6. NetCommand
Setting Up NetCommand Control of
an A/V Receiver, continued
• If the text stops flashing before the check mark
appears, repeat this step.
To erase the IR code just "learned," press CANCEL
•
while the name is highlighted.
5. Press to highlight the name Input1. You can
enter a custom name using the letters/numbers on
the remote control. It is best to assign names to
"learned" inputs that match the input names dis-
played on the A/V receiver. For this example, enter
the custom name TV using these guidelines:
• To select a character, repeatedly press a
number key on the remote control to cycle
through the characters associated with the key.
The following special characters are available
by using the 1 and 0 keys:
1: ! & blank space
0: / * -
Press ENTER to set the character and move the
•
highlight to the next character.
• To delete a character, highlight the character
and press CANCEL.
• To highlight the first character, repeatedly press
CANCEL.
6. Press to move the highlight to the Assign
column.
7. Use to highlight AudioOut (TV audio output).
The triangular marker is always next to the assigned
sound source.
8. Press EXIT if finished or continue with setup for
another TV source.
Completed NetCommand setup described for
controlling A/V receiver switching to the A/V receiver's
audio input labelled "TV."
Setup 2: Automatic A/V Receiver Switching for a
Surround Sound Device
Use this setup to send digital surround sound directly
from a device to an A/V receiver.
1. Under Learn/Name, navigate to highlight the area
next to Input2.
IMPORTANT
All audio from what you are watching on the
TV is always available as an output on both the
TV's AVR AUDIO OUTPUT and DIGITAL AUDIO
OUT jacks.
To use the digital surround sound capabili-
ties of your A/V receiver however, you must
connect your DVD player, satellite receiver, or
cable box directly to the A/V receiver, as sur-
round sound may not be available from the TV's
audio output.
In this example, the IR code for the A/V receiver's
DVD Audio input will be "learned" as Input 2.
2. Press ENTER on the TV's remote control.
Setup 2: A/V receiver audio from a device providing
surround sound directly to the A/V receiver
Completed NetCommand setup described for
controlling A/V receiver switching to an A/V receiver
input labelled "DVD."
3. While the text Input2 is flashing, press and hold the
DVD INPUT key on the A/V receiver's remote control.
4. When a check appears next to Input 2, release the
DVD INPUT key.
• If the text stops flashing before the check mark
appears, repeat this step.
• To erase the IR code just "learned," press CANCEL
while the name is highlighted.