Netcommand ® On-Screen Buttons; Control Buttons - Mitsubishi Electric LT-3280 Owner's Manual

Chapter 3: NetCommand® Setup and Editing
NetCommand
To use the media center's NetCommand feature, you need to provide some detailed information during the setup. You
must define the manufacturer of the devices that are connected to the media center, or "learn" the IR code remote
control signals for the device connected. For each device, the input to the media center and A/V receiver, and the
names for the device are pre-set during Initial NetCommand setup. You may change those inputs or names using the
Edit NetCommand or Learn screens. The buttons described below will help you navigate the screens.
On your remote control, the ADJUST
allow you to navigate left and right to different selections
on the screen. The ADJUST
to:
• Change the radio button
• Change current text box selection
• Navigate up and down on the screen
The ENTER button allows you to:
• Confirm the selected character when naming a
device
• Add or delete check marks in check boxes
• Select on-screen buttons to change screens
Text Box
Press ADJUST or
Check Box
Check marks indicate the item or input is added or turned
On. Press ENTER when the check box is highlighted to
add or delete a check mark. When viewing the Review
screen, a check box reflects which devices are turned On
or Off, or connected to the media center.
Radio Buttons
The setting changes when one of the choices is
highlighted.

Control Buttons

Much like the software on your computer, you will use
graphic buttons to navigate through the NetCommand
Setup screen. Highlight the button and press ENTER to
select the function.
48
®
On-Screen Buttons
and buttons
and buttons allow you
to make a selection.
<Back Button
Use the <Back button to navigate back to the previous
screen.
Next> Button
Use the Next> button to navigate forward to the next
screen.
Cancel Button
The Cancel button will cancel out any changes you
are currently making without saving them into memory.
When you select the Cancel key, NetCommand will
prompt you to confirm that you want to cancel the
changes you are currently making. If you select Cancel
during Initial Setup, you can setup NetCommand later by
selecting the NetCommand menu, then choosing Initial.