Appendix A: Specifications - Mitsubishi Electric LT-3280 Owner's Manual

Appendix A: Specifications

Software Updates: From time to time, Mitsubishi may offer software updates to expand the features or operation of
this media center. When these updates are available they will be announced on our web site, Mitsubishi-tv.com. If
you return your Owner's registration card, with your model and serial number, you may receive written notification of
available software updates.
Display and Media Center Specifications
Channel Frequency Reception
Channel Type
Note for Digital Channels: The channel numbers displayed on screen are determined by the broadcaster or cable company and
can vary from the standard frequency number. If there is no channel number information included from the broadcaster or cable
company, then the TV will create a channel number based on the frequency number as the main channel number and the program
number as the sub-channel number. When using an authorized CableCARD, the channel numbers are determined by the cable
company.
Inputs
Antenna/Cable input, Qty 2
HDMI (digital video/audio), Qty 2
Signal Type
Video/S-Video, Qty 2 each
Signal Type
Component Video (Y/Pr/Pb), Qty 2 sets
Signal Type
PC Input (RGB), Qty 1
Signal Type
Audio Inputs, Qty 6 pair
MonitorLink™ Control
Outputs
Video
Monitor Output, Qty 1
Signal Type
Audio
Monitor Output, Qty 1 pair
Audio Line Out, Qty 1 pair
94
Over-the-Air: VHF 2 - 13, UHF 14 - 69
Analog Cable: 1 - 125
Digital Cable: 1 - 135
Over the Air: Analog NTSC, Digital ATSC with sub-channels
(all 18 video formats)
Cable: Analog NTSC (non-scrambled)
Digital QAM 64 and 256 with sub-channels (non-scrambled)
CableCARD™: Authorized scrambled and non-scrambled digital channels
F connector, 75 ohm
HDMI standard connectors (on media center)
HDMI standards for digital audio and video. Not intended for use with personal
computers
Video: RCA Pin Plug, 1.0 V p-p, 75 ohm
S-Video: Four Pin DIN Plug
Y: 1.0 Vp-p 75 ohm
C: 0.286 Vp-p (burst signal), 75 ohm
NTSC 480i only
RCA Pin Plug (EIA-770.3 Standard Levels and Timing)
Y: 1.0 Vp-p (includes sync), 75 ohm
Pr: 700 mVp-p, 75 ohm
Pb: 700 mVp-p, 75 ohm
EIA-770.1 & EIA 770.2 480i, 480p, EIA 770.3 720p and 1080i
Mini-D Sub, 15 pin (Note: located on display rear panel)
VGA, SVGA, XGA, WXVGA, SXGA
RCA Pin Plug 500mV (full scale), 43kohm
RS-232C NOTE: Must connect to MonitorLink™ RS-232C terminal on display.
Video: RCA Pin Plug 1.0 Vp-p, 75 ohm
NTSC 480i only for recording only
RCA Pin Plug, 500 mV rms + 200 mV (full scale) for analog sources.
1.5 V + 0.5 V (full scale) for digital sources.
RCA Pin Plug, 500 mV rms + 200 mV (full scale) for analog sources.
1.5 V + 0.5 V (full scale) for digital sources.
Fixed audio ouput when connected to A/V Receiver.
(video standards)