Monitor Tilt/Input Terminal Access/Cable Management; Monitor Tilt/Input Terminal Access/ Cable Management - Mitsubishi Electric LT-2220/LT-3020 Owner's Manual

Monitor Tilt/Input Terminal Access/Cable Management

Monitor Tilt
(Figure 1)
You have the ability to adjust the viewing angle and tilt of
.
this monitor
1. Grab the TV with two hands by placing one hand on
each side of the TV.
2. Using little force, push or pull the monitor towards
you for preferred viewing position. Use caution when
pulling so that the base does not slide.
Input Terminal Access/Cable Management
(Figures 2, 3 and 4)
1. Locate the two input terminal covers located on both
sides of your TV (back panel).
2. Gently push the two push tabs the opposite direction
and push towards the side of the TV to remove the
terminal cover(s).
3. After you neatly route all of the cable downward
through the cable management slots, place the terminal
cover back into place, so the cover can close over them
(Figure 3).
4. Position the four tabs directly opposite the four slots
on the TV (Figure 3) and gently push towards the front
of the TV.
5. Slide the two push tabs into the slots on the other
side of the terminals until both tabs snap into place. Do
not force.
6. Replace the cable management cover (shield) by
lining up the three slots on the back of the television.
The shield will neatly conceal your connection cables.
62
LCD Monitor 5 8 03.indd 62
�
�
�
���
�
�
Figure 1. Monitor Tilt
Figure 2. Input Terminal Access
������ �� ��������� ����� �����
Figure 4. Cable Management Cover
5/8/2003, 3:05 PM
����
����
����
����
����
����