Mitsubishi Electric G-50A Instruction Book page 30

MENU
NEXT
Additions
Group configuration date collective deletion
• Display "G00" in the group configuration setting screen and press the
delete the all group configuration data and all interlocked operation data.
NOTE:
• When this unit is set to the slave system controller by the function select , group registration can not be
made. However confirmation of the contents of group registration is possible.
• Simultaneously press the
configuration setting. The initial setting menu screen is displayed. Select "1. GROUP SETTING" on the setting
menu screen, wait for the group setting screen to appear, and change the setting.
Set all the units and controllers to be registered in the displayed group
number.
6
Repeat operation
ler.
When all setting are completed, press the
7
NOTE:
8 The following initial setting screen is displayed.
WED 15:29
When the interlocked operation settings are performed, refer to section
"5-5 Interlocked operation setting".
When the group name settings are performed, refer to section
"5-6 Group name setting".
When the user settings are performed, refer to section "5-7 User setting".
and keys on the user operation menu screen for 2 seconds to perform group
9
When the necessary initial settings are complete, simultaneously press the
and
When returned to the user operation screen, register processing for the group
configuration information and initial set up processing for each unit and each
controller is executed.(This process takes approximately 5
to to set all groups managed by this control-
3 5
• When there are M-NET local remote controllers in the
system,always be sure to set the local remote controller
address. The local remote controller will not operate if
the address setting is not performed.
However, when the local remote controller is an MA remote
controller (PAR-20MAA) or K-control type remote controller,
setting is not performed.
• If there is a K transmission converter is a component
in the system, do not perform the group configurations
setting of this controller for the K transmission converter.
DEL.
keys on the user operation menu screen for 2 seconds.
-28-
BACK switch.
SCREEN
switch two times continuously to
7 minutes.)