Change Battery Of Quadcopter - SYMA X5SW Instruction Manual

Change battery of quadcopter

1.Push the on/off switch of quadcopter to OFF
position than open the battery cover.
2.Pull out the battery wire from the power port.
3.To charge battery, please insert the USB port of
provided
USB charging cable to anyone USB port of
computer.
The indicator on USB cable will light ON during
charging battery, than it will light OFF when
battery fully charged.
Caution:
When using the computer for charging,please remember to pull out the
charging cable before shutting down the computer.Take the battery cover,
and close the battery cover on the quadcopter.
4.Reconnect the battery wire to power port than
close the battery cover.
Charging time: about 130 minutes — Flying time: about 5.5 minutes!
Cautions when charging:
1.When charging, please put this product on a dried or ventilated area and
keep it far away from heat source or explosive product.
2.When charging, please remove the batteries from the quadcopter. Then
charging process should be supervised by an adult so as not to cause an
accident.
3.When finish flying, please do not charge the battery if the surface
temperature is still not cool. Otherwise it may cause a swollen battery or
even a fire hazard.
4.Please make sure that you use the original USB charging cable provided.
When the battery has been used for a long time, or appears to be swollen,
please replace them.
5.A battery when not in use for a long time will lose its charge automatically.
Charging or discharging too often may reduce the life of the battery.
-11-