Heatrae Sadia Electromax User Instructions
  1. Manuals
  2. Brands
  3. Heatrae Sadia Manuals
  4. Boiler
  5. ELECTROMAX
  6. User instructions

Heatrae Sadia Electromax User Instructions

Hide thumbs Also See for Electromax:
Table of Contents

Advertisement

Quick Links

Electromax Combined Electric Flow Boiler
and Direct Unvented Hot Water Cylinder
User Instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Electromax and is the answer not in the manual?

Questions and answers

Related Manuals for Heatrae Sadia Electromax

Summary of Contents for Heatrae Sadia Electromax

  • Page 1 Electromax Combined Electric Flow Boiler and Direct Unvented Hot Water Cylinder User Instructions...
  • Page 2 OVER retained as a reminder of how to operate the Electromax models and look after the When your Electromax was installed the system for trouble free operation. If you installer should have fully commissioned are in any doubt, please ask your installer the system and left it in working order.
  • Page 3 FUNCTIONS temperature is below that set it will switch on the Electromax boiler to heat the Refer to Diagram 1 to help you identify radiators and raise the room temperature. the various features and functions of the Electromax controls panel.
  • Page 4 In normal operation the system pressure problem has been rectified and reset. should be between 1 bar and 2.5 bar. Any Contact your installer or Heatrae Sadia under or over-pressurisation problem Service Department if a fault ALARM should be investigated by a competent occurs.
  • Page 5 Press PROG again. Room Thermostat. The device supplied Using the + and – buttons until with the Electromax is manufactured the correct day is shown (1 = by Danfoss and is supplied with its own Monday, 2 = Tuesday, etc.).
  • Page 6 To do this first turn supplied with the Danfoss TP 5000 off the electrical supply to the Electromax. programmable room thermostat. DO NOT REMOVE ANY COVERS UNLESS THE ELECTRICAL SUPPLY IS ISOLATED 4.2.6 Battery Replacement...
  • Page 7 DO NOT tamper with any safety valves of these should have been pointed out to fitted to the Electromax system, if a fault is you by your installer on hand-over. suspected contact a competent installer or service engineer.
  • Page 8 Contact details on back page Heating switch to the “Off” position (green switch not illuminated). Open the lower front panel of the Electromax and turn the central heating isolating valves (see Diagram below) to the off position. This will minimize the loss of water from the system.
  • Page 9 Peak” electricity. Be aware of when the day Lower the boiler flow temperature (see time “Off-Peak” periods are as the water Electromax Controls section) to give heater will automatically reheat during adequate heating to maintain comfort those times if the thermostat is calling for levels.
  • Page 10 Product name Electromax Supplier’s model identifier standard underfloor Standard underfloor Storage volume V in litres 180.0 180.0 180.0 180.0 Mixed water at 40 °C V40 in litres The declared load profile The water heating energy efficiency class of the model The water heating energy efficiency in % 36.2...
  • Page 11 Notes: User’s Instructions...
  • Page 12 Parts Center OUR NATIONWIDE NETWORK OF CUSTOMER SUPPORT ENGINEERS Tel: 0344 292 7057 Heatrae Sadia has its very own dedicated nationwide network of highly trained www.partscenter.co.uk customer support engineers so you can have peace of mind that we’re always here to help.

Table of Contents

Save PDF