Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Tennant L2
Summary of Contents for Tennant L2
- Page 1 Operator Manual 43 cm cord electric scrubber...
-
Page 2: Table Of Contents
Tennant Company INDEX 1.0 Introduction........................2 2.0 Receiving the Machine ....................3 3.0 General Safety Instructions ..................3 4.0 Removing from the Pallet ....................4 5.0 Assembly........................4 6.0 Internal Transportation ....................4 6.1 Even Floors/Short Distance .................4 6.2 Irregular Floors/Long Distance Even Floors ............4 6.3 Stairs/Steps ......................4 7.0 Powering the Machine ....................5... -
Page 3: Introduction
The training of your staff must be conducted by an authorised representative of Tennant Company. General safety conditions and accident prevention, among other regulations relating to occupational health and safety, should also be met. -
Page 4: Receiving The Machine
2.0 Receiving the machine When receiving the machine, check if any damage has occurred during transportation. If so, confirm the damage with the carrier and immediately contact Tennant Company or our authorised representative. Tennant Company Australia Tennant Company New Zealand... -
Page 5: Removing From The Pallet
Tilt the Tennant L2 back, supporting it by the rear wheels and push it forward. 6.3 Stairs/Steps The handles of the chassis (03) will allow the Tennant L2 to be carried and transported easily by two people. Rev.03/2010... -
Page 6: Powering The Machine
The capacity of the solution tank is 33 litres. 8.3 Placing the Brush or Pad Driver Place the brush or pad driver in front of the Tennant Lean the machine back and push it over the accessory (14) centering it with the drive hub (15). -
Page 7: Solution Flow
Tennant Company 8.4 Solution Flow The water/solution flow valve (17) is used to regulate the quantity of solution flow according to the dirt, work speed and type of floor. Turning the valve counter clockwise: it gradually reduces the water flow. -
Page 8: Scrubbing During Operation
(30) and discharging the water into a drain. Remove and wash the squeegee. Wash the brush or pad. Use a damp cloth for cleaning the outside of the Tennant (do not use a hose or high pressure equipment for cleaning). Rev.03/2010... -
Page 9: Maintenance Chart
Every 12 MONTHS BRUSH MOTOR **Replace the electric contacts. or 1000 hours *Plastic base has a limit height of at least yellow bristles. ** Consult your Authorised Representatives or Tennant Company. 14.0 Technical Information Technical Chart Cleaning Capacity (m²/h) Up to 1600... -
Page 10: Warranty
Tennant Company 15.0 Warranty The Tennant L2 is guaranteed against defects in manufacture and operation for period of 24 months on parts and 6 months labour or 1000 hours, whichever occurs first from date of purchase when maintained and operated in accordance with instructions of this manual and when operated in normal cleaning conditions.
Need help?
Do you have a question about the L2 and is the answer not in the manual?
Questions and answers