Advertisement
ILwAn.,.o
• ALL RANGES
CAN TIP
• INJURY
TO PERSONS
COULD
RESULT
• INSTALL
ANTI-TIP
DEVICE
PACKED
WITH
RANGE
• SEE INSTALLATION
INSTRUCTIONS
STABILITY
DEVICE
INSTALLATION
INSTRUCTIONS
FOR BRACKET
KIT NO. 342473
TOOLS NEEDED:
Phillips head screwdriver
1 3/8" open end or adjustable wrench
Bracket attaches to floor or wall to hold either fight or left
raarleg leveler.
If faetenlng tofloor, besumthat
screws
do not penetrate electrical wiring or plumbing. If this
cannot be determined, use shorter screws that will not
penetrate through flooring.
If the bracket came with your range, It Is shipped at-
tached to the lower range back. Remove and discard
the shipping screw that holds the bracket and then
follow Instructions below.
1. Decide whether the bracket will be Installed on the
right or left side of range location.
2. If the bracket side of the range Is adjacent to a
cabinet, place the bracket against beck wall and
cabinet as shown In Figure 1.
If there Is no adjacent cabinet, determine where the
location of the range side (painted outside panel) will
be. Place the bracket with Its outside edge at this
location and agalnet back wall. See Figure 1.
3. Dstermlnewhether
you will anchor tbe brscket tothe
floor or wall. Fasten the bracket securely with the
screws provided. Screws are sclf-dfilllng
In wood,
plywood, particle
and chip board, and most metal
framing. Ifettschleg to mesonry, you can buy suIfable
screws
and anchors
at hardware
stores.
USe a
masonry
drill to drill the required holes.
4. Using the wrench, back out the four leg levelers at
lesst two tums. See your Inetalletlon guide for more
leveling Informstlon before positioning range.
5. Slide the range Into place. Be sure rear leg leveler
fully engages slot In bracket. If range cannot be
moved back far enough for rear leg leveler to enter
bracket, move bracket forward as requlrad and attach
to floor In new location.
ADJACENT
CABINET OR FINAL
LOCATION
OF RANGE SIDE
PANEL
___
OUTSIDE EDGE OF
BRACKET TO BE
FLUSH WITH LEFT OR
RIGHT SIDE OF RANGE
\
WALL BEHIND
BRACKET
SCREW MUST ENTER_
WOOD OR METAL ]
WALL
PLATE
ATrACHMENT TO WALL
Fig. 1
Fig, 2
1
NCINS01-2
Advertisement
