Sms Remote Control & Table Of Command Code - Ltl Acorn Ltl-6310M User Manual

camera wakes up to either receive or execute the commands. "0" indicates that the camera will
wake up and search for commands automatically every 10 minutes, and send feedback once it
receives them. "1~24" indicates search intervals of 1~24 hours.. "off", on the other hand, means
SMS remote control is turned off. This design with the waking intervals helps conserve battery.
Select value based on your own need. To learn more about SMS remote control please refer to
2.7. Setup in need only when SMS remote control in use, you can set it up by MMS or Smtp
Setup)
Click on to find and choose the drive where the SD card is under. (For example, F:/)
Click on
will be created and saved in the root directory of the SD card.
Finally, insert SD card into camera and power on the camera. The camera will be ready to go..
2.7 SMS Remote Control & Table of Command Code
In order to communicate with your camera via text message/SMS, you need to format your texts
in a certain way, essentially speaking the same language as the camera.

All the SMS commands should start with "LTL(ltl)" and end with "AA(aa)".

Between "ltl" and "aa", insert the specific instructions you want the camera to follow. You
can choose to give one instruction at a time, but it saves time to combine them together.

A specific instruction is made up with four parts in the following sequence: a two-digit order
code, an asterisk (*), a code value (a number or a combination of numbers and letters), and
lastly a pound/hash sign (#). See the "Example" column for illustrations.

Both capitalized and non-capitalized letters can be used in a command.

Do NOT leave any spaces between any of the letters and symbols.

Do NOT put a comma or a period at the end of the text. Again, a command starts with "ltl"
and ends with "aa". Do NOT include any quotation marks in a command; they are used here
just for explanation purposes.

A text can only include one command. If you want to send multiple commands, please do so
in separate texts.
An example of a command would be LTL01*0#02*2#06*S30#07*10A3Z#60*1#AA
Which asks the camera to 1) be in camera mode and take only pictures, 2) set image size to 2MP,
3) take pictures with an interval of 30 seconds, 4) turn on serial number and set it to "0A3Z", and
5) immediately take a picture and send it to you.
. A message window pops out as below. Click OK. A file named smtp.dat
- 13 -