Video Setup Menu; Lan Setup Menu; Video Input; Custom Input Label (Hdmi-In(Pc) - Sony Ipela PCS-XC1 Operating Instructions Manual

Ringer Tone
Allows you to select the volume of a ring
tone when you receive a call from among
"Loud", "Medium" and "Quiet". You can
also select "Off" for the ring tone not to be
output.

Video Setup Menu

The Video setup menu is used to set up video
input/output.
Video1
Basic Setup

Video Input

Allows you to select the video input.
Camera: Selects the picture from the unit's
camera.
HDMI-IN(PC): Selects the video signal
from the external equipment connected
to the HDMI IN (PC) connector.
Frequency
Allows you to select the frequency of 50 Hz
or 60 Hz for video input/output.
Notes
• "Frequency" is set to "60 Hz" at the factory.
Note that video may not be output or the
menu not displayed on the screen when
"Frequency" is set to "50 Hz" if the
connected equipment does not support the
frequency of 50 Hz.
• You must reboot the unit to apply changes to
the "Frequency" setting. Reboot the unit
manually. If you change it to an incorrect
setting, no picture is displayed on the screen
after rebooting. In this case, select the correct
setting for "Frequency" using the
switch on the unit and the buttons on the
Remote Commander.
Perform the following at least 2 minutes after
the unit finishes rebooting.
1
1 Press the (power) switch on the unit.
2 Within five seconds after you pressed the
switch, press the buttons on the Remote
Commander described below depending
on the desired Frequency.
60 Hz: VIDEO INPUT button (once)
then Number button 1 (three times)
50 Hz: VIDEO INPUT button (once)
then Number button 2 (three times)
The "Frequency" setting is changed, and the
unit shuts down. Press the
on the unit again to turn on the unit.
Video2
Label
Allows you to set the names of the selected
video inputs using up to 12 characters.
Custom Input Label (Camera)
Selects when "Camera" is selected in
"Video Input".

Custom Input Label (HDMI-IN(PC))

Selects when "HDMI -IN(PC)" is selected in
"Video Input".

LAN Setup Menu

The LAN setup menu is used to set up LAN
connection.
For details about the settings, consult your
network administrator.
LAN
Host Name
Enter your host name (up to 30 characters).
DHCP Mode
Allows you to select whether the Dynamic
Host Configuration Protocol (DHCP) server
is enabled.
Auto: The IP address, network mask,
gateway address and DNS address are
1
(power)
automatically assigned.
Off: Disables the DHCP server. In this case,
enter an IP address, network mask,
gateway address and DNS address.
Prefix Length
Configure the prefix length of the IPv6
address within the range of 0 to 128.
IP Address
Enter the IP address.
1
(power) switch
Custom Input
Basic Setup: LAN
Registering Local Information
49