Table of Contents
Advertisement
TTB579PLN by TITAN
2) Fitting the blades
> Fit the blade correctly into the clamping device.
> Slide both components into the cutter-block, taking care that they are fitted in
the correct direction etc.
> Centre the blade assembly laterally.
> Set the blade setting block (40) over the cutterblock.
> Pull the setting block back so that it sits firmly against the front edge of the planing
out-feed table.
> Put firm downward pressure on the setting block whilst keeping it firmly against
the edge of the out-feed table. This will push the blade into place.
> Keep firm pressure on the setting block and tighten the 5 blade tensioning screws.
> Once complete, turn the cutter-block to expose the 2nd blade and repeat the
process to replace that blade.
NOTE: Once this operation is complete, ensure that the cutter-
block turns freely by hand before re-connecting the machine to the
mains supply. Replace all safety guards immediately after
completing this operation.
Fig. 40
Replacing the motor brushes
Caution: This operation should only be carried out by a suitably
qualified person.
> Carefully turn the planer thicknesser onto its side.
> This will expose the motor of the machine.
> Take a slotted screwdriver (not supplied) and locate it in the slot on the motor
brush cap.
Care and maintenance
40
Fig. 41
GB
IE
Fig. 42
32
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TTB579PLN and is the answer not in the manual?
Questions and answers
How do you fit the blade guard to the underneath thanks
To fit the blade guard to the underneath of the Titan TTB579PLN:
1. Locate the blade guard limiting knob pole (c) on the side of the planer out-feed table (13).
2. Slide the guard arm and cutter guard assembly (27) over the locating pivot pin.
3. Tighten the locking knob (28) by turning it clockwise.
4. Align the opening of the retaining collar (29) with the groove (b) on the blade guard locating pivot pin (a).
5. Use sharp-nose pliers (not supplied) to push down the retaining collar (29) and secure it to the groove (b).
This answer is automatically generated