Table of Contents
Advertisement
Chapter 2 Convenient Features
4.
RAID System Configuration
This section describes the RAID configuration utility, the LSI Software RAID Configuration Utility.
Because this utility resides in LSI Embedded MegaRAID, its operation is independent of the OS.
Jumper settings on the motherboard required to use the RAID controller (LSI Embedded MegaRAID) is
described in the images below.
4.1
Running the LSI Software RAID Configuration Utility
When the message below appears on the POST screen after turning on the server, press the <Ctrl> + <M>
keys or <Enter> key. The LSI Software RAID Configuration Utility starts.
Press Ctrl-M or Enter to run LSI Software RAID Configuration Utility
Tips
If you failed to perform key operation as described above and the following screen did not
appear, restart the server and retry.
Express5800/R120d-1E, R120d-2E Maintenance Guide
RAID Configuration Jumper (RAID_KEY1)
1
1
2
2
3
3
Enabled
Disabled
(Factory setting)
4. RAID System Configuration
95
Advertisement
Table of Contents
