Panasonic UF-5300 Operating Instructions Manual page 40

Customizing Your Machine
Fax Parameter Table
No.
133
135 JUNK FAX FILTER
136 RESTRICT D. DIAL
137 RE-ENTER D. DIAL
NOTE
40
Downloaded From ManualsPrinter.com Manuals
Setting
Parameter
Number
JOB BUILD 1
2
1. JUNK FAX FILTER
1
2
2. RECEIVE WITHOUT ID
NO.
1
2
3. RECEIVED ID PRINT
1
2
4. ID NO.
REGISTRATION
(NO. 01-30)
1
2
1
2
1. The standard settings are printed on the Fax Parameter List. To print out Fax Parameter List.
(See page 135)
2. The contents of Fax Parameter may differ depending on regulations and specifications in the
countries.
Setting
OFF Selecting whether the machine performs Job Build when
the total number of documents exceed the maximum
ON
capacity of the ADF, or when scanning the documents
manually one at a time. If you place the documents on the
ADF within 5 seconds after the ADF scan, the ADF scan
will continue for the current scan. (Maximum number of
scanning papers is 255 pages for one job.)
The Quick Memory Transmission feature (Fax Parameter
No. 82) is not available when the Job Build is set to
"2:ON".
Up to 250 pages can be stored. When the number of
pages exceeds 255, the memory overfull message will be
displayed. Select "Yes" to start transmitting, or "No" to
cancel. If no action is taken within 5 seconds, the machine
will start transmitting the stored originals.
Function to prevent direct mail FAX and unnecessary FAX
messages.
When set to "VALID", the machine will not receive the
faxes from the senders whose numeric ID has been
INVALID
registered as junk fax number. The denied number IDs can
VALID
be registered in "4.ID NO. REGISTRATION".
When set to "VALID", the machine will receive the faxes
from senders without numeric ID registered.
(This setting is available only when "1. JUNK FAX FILTER"
INVALID
is set to "VALID".)
VALID
When set to "VALID", the sender's numeric ID and
received time are printed at the bottom of the received
INVALID
faxes. If the sender's numeric ID is not registered, only the
VALID
received time is printed. (This setting is available only
when "1. JUNK FAX FILTER" is set to "VALID".)
Register fax numbers as junk fax number.
Up to 30 fax numbers can be registered for junk fax
number. (Including numerals "0-9", blank space, and +
symbol.) (When comparing the sender's numeric ID to the
registered junk fax numbers, blank spaces between
numbers are ignored.)
INVALID Enable or disable the Restrict Direct Dial function.
When set to "VALID", manual input destination Tel No. and
VALID
"Redial" button are not accepted.
INVALID Used to set whether to display the address reinsert screen
when indicating the address for direct dial, inputting the
VALID
mail address for Internet FAX, redialing or inputting the
address for confirming the address. When set to "VALID",
unit will require input destination Tel No. or Mail address
twice for confirmation. Unit will proceed transmit job when
destination data is matched.
This setting is not available when the Restrict Direct Dial
function is set to "VALID".
Comments