Problem Solving; Troubleshooting - Panasonic UF-5300 Operating Instructions Manual

Problem Solving

Troubleshooting

Troubleshooting
If You Have Any of These Problems
Mode
During Transmission
Transmission Copy
Quality
During Reception
Downloaded From ManualsPrinter.com Manuals
Symptom
Document doesn't 1. Check that your document is free of staples and paper
feed/multiple feed clips, and that it is not greasy or torn.
2. Check that your document is the right type to send through
a fax machine by consulting the list on "Documents You
Cannot Send". If your document has the characteristics
listed, make a photocopy of your document and send the
copy instead.
3. Check that the document is loaded properly.
4. Adjust the ADF Pressure.
Document jam The information code 030 or 031 will appear on the display if
the document becomes jammed.
Does not stamp 1. Check if Stamp LED is lit.
2. Check Fax parameter No. 04 and No. 28 settings.
Stamp too light Replace stamp.
Vertical lines on the Check own copy quality. If copy is OK, your machine has no
transmitted document problem, so report to the receiving party that they have a
problem. If copy is NG, clean the Document Scanning Area.
Transmitted document 1. Make sure the document is set face down.
is blank 2. Check own copy quality. If copy is OK, your machine has
no problem, so report to the receiving party that they have a
problem. If copy is NG, clean the Document Scanning
Area.
No recording paper The information code 010 will appear on the display if the
paper runs out.
Recording paper jam The information code 001, 002, 007 or 008 will appear on the
display if the paper gets jammed.
Recording paper Make sure that there is paper in the Paper Cassette. Follow
doesn't advance into the instructions for loading paper.
machine
Recording paper Check to see if the recording paper is jammed inside of the
doesn't eject after machine.
printing
Recording papers are Check if Fax Parameter No. 65 is set to valid.
not stacked in
sequence. Machine
does not print from the
last page received.
Document auto Check Print Reduction settings.
reduction doesn't work
Out of toner The information code 041 will appear on the display if the
Toner Cartridge runs out of toner.
Cause / Action
Continued on the next page...
page
42
43
148
145
45
36
37
149
146
146
20
144
20
144
39
72
18
137