BASE STATION
BASE STATION
Figure 1-1 Base Station Front View
Base Station Power
1-4
The IP4100 Base Station requires Power Over Ethernet.
1. Connect a standard Ethernet cable (Cat 5 or higher) to the Ethernet/
PoE jack on the rear of the base station. Route the cable through the
channel as shown in
2. Connect the other end of the cable to your TCP/IP network.
3. When the base station powers on, the STATUS LED on the front
briefly lights orange and then turns off while it initializes and connects
Figure 1-2 Base Station Rear View
Figure
1-3.
IP4100 Install Sept., 2013
Base Station Power