Dhcp Relay Commands - D-Link DES-1228/ME Reference Manual

The DHCP Relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command
config dhcp_relay
config dhcp_relay add ipif
config dhcp_relay delete ipif
config dhcp_relay option_82 state
config dhcp_relay option_82 check
config dhcp_relay option_82 policy
config dhcp_relay option_82
remote_id
show dhcp_relay
enable dhcp_relay
disable dhcp_relay
Each command is listed in detail in the following sections:
config dhcp_relay
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To config DHCP relay:
DES-1228/ME:5#config dhcp_relay hops 2 time 23
Command: config dhcp_relay hops 2 time 23
Success.
DES-1228/ME:5#
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Used to configure the DHCP/BOOTP relay feature of the switch.
config dhcp_relay {hops <value 1-16> | time <sec 0-65535>} (1)
This command is used to configure the DHCP/BOOTP relay feature.
hops <value 1-16> − Specifies the maximum number of relay agent
hops that the DHCP packets can cross.
time <sec 0-65535> − If this time is exceeded; the Switch will not
relay the DHCP packet.
Only Administrator level, Operator level or Power User level users can
issue this command.
DHCP R
Parameters
{hops <value 1-16> | time <sec 0-65535>} (1)
[System] <ipaddr>
[System] <ipaddr>
[enable | disable]
[enable | disable]
[replace | drop | keep]
[default | user_define <string 32> ]
{ipif [System]}
185
20
C
ELAY OMMANDS