Samsung OfficeServ 7200 Technical Manual page 38

OfficeServ 7200
TECHNICAL MANUAL
1
1
J2
J1
JUMPER SETTING FOR TEPRI
The TEPRI board comes from the factory with the following jumper settings. These settings
should NOT be changed.
• J1 & J2: Pins 2 & 3 connected
• J3: Pins 2 & 3 connected
• J4~J9: Pins 1 & 2 connected
• Pin 1 is labeled on the board for each jumper.
JUMPER SETTING FOR TEPRIa
The TEPRIa board comes from the factory with the following jumper settings. These settings
should NOT be changed.
• J1 and J2: Connect #1 and #2 for E1 cable #2 and #3 for T1 cable.
S2 OFF
1 E1
2 T1/E1
3 24B + D
4 User
Figure 3.19 Setting Switches on the TEPRIa Board
3.20
Home Page
INSTALLATION
PART 3 MAY 2010
ON
4
1
OFF
S2
ON
T1
PRI
24B
Network
Table of Contents