Toshiba MJ-1104 Service Manual page 194

(5) Press the [Button1] to adjust the alignment position.
Every time the [Button1] is pressed, the alignment plate shifts 1 step (0.419 mm/step) toward the
"+ "direction. (The gap between the alignment plates becomes narrower.)
Adjustment range is from -5 to +5 steps.
If the [Button1] is pressed when the alignment position is at the "+5 step", the plate will return to
the home position and then moves to the position of "-5 step".
(6) Place the adjustment sheet on the process tray and adjust the position to make the gap between
paper and the alignment plate "0".
Then setting is performed at a value that is one smaller than the adjustment value.
Remarks:
• Use an adjustment sheet made of plastic resin which is light and accurate in measurement
(e.g. OHP film).
• To reduce frictional resistance with the vertical alignment roller on the process tray, place a
sheet of B5 paper beneath the adjustment sheet on the vertical alignment roller.
• Confirm the gap between paper and the alignment plate by moving the adjustment sheet for-
ward and backward to reduce affect by backrush of the gear of the side alignment plate.
MJ-1103/1104
ADJUSTMENTS
LED3 LED2
Button1
Fig. 5-2
alignment plate
B5 paper Vertical
Adjustment sheet alignment roller
Fig. 5-3
5 - 2
LED1
Button2
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved