[F] Exit sensor (S31)
(1)
Open the front upper cover and then pull out
the saddle unit.
(2)
Remove 1 screw, and then disconnect the
connector and take off the sensor bracket.
(3)
Release the latch, and then take off the exit
sensor.
[G] Saddle tray paper detection sensor (S32)
(1)
Open the front upper cover and then pull out
the saddle unit.
(2)
Remove 1 screw, and then disconnect the
connector and take off the sensor bracket.
Note:
When the sensor was installed, be sure to
adjust the position of the sensor bracket.
P.4-26 "[A] Saddle unit"
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
Sensor bracket
Exit sensor
Sensor bracket
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 114
Fig. 4-323
Fig. 4-324
Fig. 4-325