Toshiba A20-S259 - Satellite - Pentium 4 2.66 GHz Maintenance Manual page 414

4.30 Fluorescent Lamp
Assembling the 14.1-inch XGA Sharp Fluorescent Lamp
To assembling the 14.1-inch XGA Sharp fluorescent lamp, follow the steps below and refer to
figures 4-155 to 4-159.
1. Attach the lamp cover (F) and attach the shield tape to the lamp cover after folding it. Then
fix the lamp cover with the two screws (E).
The attached lamp cover must not cover the heads of the engaging pins.
Around the opening for extracting the lead, the edge of the P chassis should go beyond the
edge of lamp cover.
2. Fix the GND lead wire with the fixing tape. Check that the guide rib is not overlaid with the
panel. After fitting the U-shaped side of the bezel to the P chassis, attach the bezel by
pressing the two latches close to the lamp into place.
Satellite A20 Maintenance Manual (960-444)
Figure 4-155 Replacing the lamp unit
Figure 4-156 Attaching the bezel
4 Replacement Procedures
4-195