Starting The D-Link Embedded Web Interface - D-Link DES-3010FA Web User Manual
Layer 2 switch, managed 8 port 10/100base-tx with gigabit & fiber uplinks
Hide thumbs
Also See for DES-3010FA:
- Cli manual (361 pages) ,
- Cli manual (348 pages) ,
- Manual (348 pages)
Table of Contents
Advertisement
D-Link DES-3010FA/GA User Guide
Starting the D-Link Embedded Web Interface
This section contains information on starting the D-Link Embedded Web interface. To access the D-Link user
interface:
1.
Open an Internet browser.
2.
Ensure that pop-up blockers are disabled. If pop-up blockers are enable, edit, add, and device information
messages may not open.
3.
Enter the device IP address in the address bar and press <Enter>. The Enter Network Password Page
opens:
Figure 15: Enter Network Password Page
4.
Enter your user name and password.
Notes
•
The device is configured with a user name that is admin and a password that is blank, and can be
configured without entering a password.
•
Passwords are case sensitive.
•
To operate the device, disable all pop-ups with a popup blocker.
5.
Click
. The D-Link Embedded Web Interface Home Page opens:
Page 50
Advertisement
Table of Contents
Troubleshooting
