Table of Contents
Advertisement
Item
Video
Resolution
Bitrate
Scene Change Detection
OETF/Colorimetry
Audio
Type
Channels
Ancillary
Filter Rule
DID
Description
Selects the video resolution.
• 3840×2160p
• 1920×1080p
• 1920×1080i
• 1280×720p
Selects the video transmission bit rate.
• High: Setting to transmit with high image quality.
• Middle: Recommended setting.
• Low: Setting to economize on bandwidth.
• Manual: Set manually.
Notes
• The following configurable ranges are available when set to [Manual].
4K:35 to 200 Mbps
HD: 12 to 100 Mbps
• [High] may not be selectable, depending on the configuration.
• When [WAN] > [Streaming] > [USB] is selected on the [Network] tab (page 29) of the
[Maintenance] page in the web menu, the maximum value for [Bitrate] is 100 Mbps.
Selects whether to detect scene changes in the input signal to optimize the encoding
process.
• OFF: Suitable for camera output transmission.
• ON: Suitable for program out transmission.
Selects the OETF and color gamut.
• Auto
• SDR/709
• SDR/2020
• HLG/2020
• S-Log3/2020
Notes
• When a setting other than [Auto] is selected, transmission occurs using the specified
value regardless of the signal content.
• Selection options other than [SDR/709] may not be selectable, depending on the
configuration.
• There is no OETF/Colorimetry conversion function.
Displays the type of audio to transmit.
• LPCM
Selects the number of audio channels to transmit.
• 0ch
• 2ch
• 4ch
Note
The set value must match the [Audio] > [Channels] setting in the receive list set for the
paired receiver.
Selects the mode for ancillary data transmission.
• Include: Transmits ancillary data specified using DID.
• Exclude: Transmits ancillary data other than the data specified using DID.
• Disable: Do not transmit ancillary data.
Note
Not all specified ancillary data can be transmitted.
When [Include] or [Exclude] is selected, the ATC (Ancillary Time Code) is transmitted
regardless of the DID setting. ATC is also not transmitted when [Disable] is selected.
Specifies the DID used by the filter rule when transmitting ancillary data. Up to eight can
be specified.
24
Advertisement
Table of Contents
