Replacing The Audio In Connector - Sony Digital HDVS HDC-900 Maintenance Manual

3-12. Replacing the MIC Connector
5. Disconnect the connectors (CN1 and CN2) of CN-
2026 board.
CN-2026 board CN2
6. Remove the tow screws, and remove the FRONT MIC
connector with pressing connector lever.
Lever
FRONT MIC connector
7. Install the new FRONT MIC connector in the reverse
order of steps 1 to 6.
3-16 (E)
CN1
P2.6 x 5

3-12-2. Replacing the AUDIO IN Connector

1. Loosen six screws, and pull out MIC panel assembly.
n
When pulling out a MIC panel assembly, pay full
attention to the harnesses and or flexible card wires
connected to the MIC panel assembly so that they are
free from incurring any damages.
2. Disconnect the connectors (CN2, CN5) of CN-1951
board and from CN-2063 connector (CN4). Also,
disconnect a flexible card wire from the connector
(CN6) of CN-1951 board.
n
Refer to Section 1-5 for details on disconnecting/
connecting the flexible card wire.
CN4
( CN-2063 board )
CN3
( CN-1955 board )
Precision
P2.6 x 8
CN5
( CN-1951 board )
Precision
P2.6 x 8
(with stopper)
CN6
( CN-1951 board )
CN2
( CN-1951 board )
MIC panel assembly
HDC-900/950 MM