Table of Contents
Advertisement
Specifications
Inputs
LINE IN: Phono jacks, 245 mV
(-10 dBs), 50 kilohms
TAPE IN: Phono jacks, 245 mV
(-10 dBs) 50 kilohms
Outputs
LINE OUT: Phono jacks, 245 mV
(-10 dBs),
Load impedance: more than 10
kilonms
TAPE REC OUT: Phono jacks, 245 mV
(-10 dBs),
Load impedance: more than 10
kilohms
Graphic equalizer
Boost/cut range: + 10 dB
Center frequencies: 63 Hz, 160 Hz,
400 Hz, 1 kHz, 2.5 kHz, 6.3 kHz,
16 KHz
Frequency response (with EFFECT OFF)
LINE IN: 20 Hz to 50 kHz, *°, dB
Harmonic distortion
LINE IN: Less than 0.01 %
(at 1 kHz, 1 V output)
Signal-to-noise ratio (with EFFECT OFF)
LINE IN: Better than 100 dB
(A network, 1 V output)
Power requirements
120 V AC, 60 Hz
Power consumption
13W
AC outlet
1 unswitched, 120 W/1A max.
Dimensions
Approx.430 X 110 X 265mm (w/h/d)
(17 x 4/, x 10 '/, inches)
including projecting parts and controls
Weight
Approx. 3.2 kg (7 ib 1 oz)
Accessories supplied
Audio connecting cords (2)
Remote commander RM-J711(1)
Sony batteries SUM-3 (NS) (2)
Design and specifications are subject to change without
notice.
Troubleshooting
Before going through the check list below, first refer back to
the connections and operating procedures.
Should any problem persist after you have made these
checks, consult your nearest Sony deaier.
Trouble
Cause
No audio even when
the POWER switch is
turned on.
© The power cord is
disconnected.
® The connecting cord is
disconnected.
No equalization
© The EFFECT button is switched
off (the indicator is off).
¢ Connections are not made
properly.
The operation cannot
be performed with the
remote commander.
¢ Check that the batteries are
loaded correctly.
* Check if there is any obstacle
between the remote
commander and this unit.
¢ Check if the batteries are
exhausted.
11
Advertisement
Table of Contents
