Product Inspection And Storage; Product Inspection; Storage - Toshiba LF150 Instruction Manual

1. Product Inspection and Storage

Upon arrival of the product package, open the package and check the items contained inside. If
you do not install the product shortly afterward, store the product and other related items in a
place as described in 1.2 below.

1.1 Product Inspection

The LF150 electromagnetic flowmeter detector is shipped in a container filled with
shock-absorbing materials. Open the package carefully and check as follows:
Make sure the following items are included in the package.
For the separate type (when a converter and detector are separated)
Electromagnetic flowmeter converter---------------------------------- 1 unit
Electromagnetic flowmeter detector ----------------------------------- 1 unit
Instruction manual -------------- Once each for the converter and detector
Inspect the detector for indications of damage that may have occurred during shipment.
Make sure the type and specifications of the detector (meter size, wetted materials,
protective coating, etc.) are in accordance with the ordered specifications.
If you can not find the items listed above or any problem exists, contact your nearest Toshiba
representative.

1.2 Storage

To store the LF150 detector after opening the package but you will install it at a later date,
select a storing place as follows and keep it under the conditions as described:
(1) Avoid the place where there is direct sunlight, rain or wind.
(2) Store the product in a well-ventilated place. Avoid the place where it is extremely high
in humidity, extremely high or low in temperature. The following environment is
recommended.
• Humidity range: 10 to 90% RH (no condensation)
• Storage temperature range: –15 to +65 °C
(3) Avoid the place where vibrations or mechanical shock occurs.
(4) Do not open the terminal housing cover of the detector. Open it only when you actually
wire cables. Leaving the cover open may cause gradual deterioration of circuit isolation.
Note that
the detector whose cables are wired already at the time of shipment is not
needed to open the detector housing cover.
7
— —
６Ｆ８Ａ０９１６