Table of Contents
Advertisement
C-100
2-9.
SIDE-004 BOARD
Note 1: The SIDE-001 board, SIDE-002 board and SIDE-004 board
are repair parts as a unit of three boards together, whose volt-
age adjusted at the factory.
Therefore, if it is necessary to replace one of the boards of
SIDE-001 board, SIDE-002 board or SIDE-004 board, be sure
to replace three boards at the same time.
SIDE-001 board
SIDE-004 board
wire [white]
SIDE-004 board
wire [black]
microphone frame
capsule side
Note 8: The wires must not touch the microphone frame.
1 Remove the two
solders of wire.
8 SIDE-004 board
Note 4: When installing the SIDE-004
board, align the boss and notch,
and take care so that the wires
do not get pinched.
6 Remove the solder
of wire. [black]
capsule side
7 lug
5 terminal
Note 6: Solder within the
guide line.
Solder
lug
[black]
guide line
guide line
12
SIDE-004 board
SIDE-004 board
wire [yellow]
wire [red]
– Top view –
2 Remove the five
solders of wire.
3
notch
4 Remove the solder
of wire. [gray]
Note 7: When soldering, make sure that
the solder does not go around to
the back side.
Solder
terminal
Note 2: The slide switch mounted on the SIDE-004 board can be
replaced singly. For the slide switch, refer to "SECTION 5
ELECTRICAL PARTS LIST" on page 21.
SIDE-004 board
wire [blue]
Note 3: Set the wires so that they are not higher
than the microphone frame.
capsule side
microphone frame
SIDE-001 board
SIDE-002 board side
boss
SIDE-002 board
SIDE-004 board
wire [purple]
capsule
side
microphone
frame
[gray]
guide line
– Side view –
connector side
SIDE-004 board
wire [brown]
–
–
Note 5: Set the wires so that they
do not crossover or touch
the microphone frame.
Advertisement
Table of Contents
