Commissioning - Bosch Rexroth CytroPac Operating Instructions Manual

8 Commissioning

Activation of machine functions by means of commissioning!
Danger to life, risk of injury!
▶ Before commissioning of the hydraulic power unit, make sure that all
electrical, mechanical and hydraulic connections are properly installed and
connected as described in the superior instructions of the machine/system
manufacturer.
▶ Make sure that the safeguards are activated.
Leakage of hydraulic fluid under high pressure due to faulty assembly of the
hydraulic power unit!
Risk of injury, damage to property!
▶ Ensure that the hydraulic power unit has been mounted by an expert,
see chapter 2.4 "Qualification of personnel", completely and without any
tension stress before commissioning of the hydraulic power unit.
For commissioning, also take into account the commissioning instructions
51055-IB, see chapter 1.2 "Required and amending documentation".
There, you will find further information about installing IndraWorks DS, power-on
sequence, connection establishment, and IndraWorks DS and CytroPac features.
According to EC Machinery Directive 2006/42/EC, commissioning must not be
undertaken until it has been determined that the machine to be equipped with
the hydraulic power unit complies with the provisions of all relevant directives.
Combination of components may lead to additional/other types of hazards.
For commissioning of the hydraulic power unit, always observe the operating
instructions of the overall machinery/system.
This particularly applies to "Mechanical hazards" due to mechanical motions of
the machine initiated by the hydraulic power units and drives (cylinder, motor).
Bosch Rexroth recommends bleeding and flushing the hydraulic system before
connecting the CytroPac.
Please observe the operating instructions of the machinery/system.
Commissioning | CytroPac
WARNING
RE 51055-B, Edition 07.2022, Bosch Rexroth AG
53/80