Table of Contents
Advertisement
Operating the Image
Processor Unit
You can switch the video display of the head mounted
monitor by operating the front panel of the image
processor unit.
Setting configurations will be stored, even after you turn
off the image processor unit.
Selecting the Input Signal
Use the INPUT buttons to switch input signals.
When using PinP display, you can switch the input
signals for the main screen and sub-screen separately.
To switch the input signal for the main screen
If the sub-screen is displayed, press the PIP button to turn
off the sub-screen display, and then press the INPUT
button.
To switch the input signal for the sub-screen
Press the PIP button to turn on the sub-screen display, and
then press the INPUT button.
When you press the INPUT button, the input signal is
switched in the order indicated by the following table.
The input mode appears in the SUB display on the front
of the unit. When the input mode is "6," pressing the
INPUT button resets it to "1."
Input mode
Description
1
Displays video from the DVI-D 1(2D) input
connector in 2D.
2
Displays video from the DVI-D 2(3D) input
connector in 3D.
This mode supports only videos in split left/
right format.
3
Displays video in 3D when the left-eye and
right-eye videos of a 3D video are input via
separate cables to the DVI-D 1(2D) and
DVI-D 2(3D) input connectors.
This mode cannot be used at the same time
as modes 1 and 2.
4
Displays video from the SDI 1(2D) input
connector in 2D.
5
Displays video from the SDI 2(3D) input
connector in 3D.
This mode supports only videos in split left/
right format.
6
Displays video in 3D when the left-eye and
right-eye videos of a 3D video are input via
separate cables to the SDI 1(2D) and SDI
2(3D) input connectors.
This mode cannot be used at the same time
as modes 4 and 5.
When a remote controller is connected, control signal
inputs perform the same function as the INPUT button
and allow you to switch the input signal.
Holding down the INPUT button resets the input mode to
"1." If you select the wrong input mode using a remote
controller, press the remote controller switch repeatedly
until you select the correct mode.
Displaying a Sub-Screen (PinP)
Press the PIP button to display the sub-screen of the PinP
function.
Pressing the PIP button again turns off the sub-screen.
Flipping the Image
Press the FLIP button to flip the video image. The display
changes in the following order with each press of the
FLIP button. The current flip mode is displayed on the
front panel of the unit.
Normal display
Left/right flip display
180-degree rotation display
When the left/right flip and 180-degree rotation display
modes are selected, the flip mode will also be reflected in
the head mounted monitor's display.
Head mounted monitor's screen
Flip mode (main)
Main screen
If the sub-screen is displayed when you press the FLIP
button, the sub-screen's display will change. If only the
main screen is displayed, the main screen's display will
change.
If you want to change the main screen's display while the
sub-screen is displayed, press the PIP button to turn off
the sub-screen first.
Flip display settings are stored for each input mode.
Operating the Image Processor Unit
Flip mode (sub)
Sub screen
27
Advertisement
Table of Contents
